A Chevrolet 502 if you want to do all the work that would take. Realistically, a 1.8L DOHC 16V out of the Geo Storm GSI is about the most you're gonna fit in there.
80W
i want to know if a new clutch was put in a 1990 geo storm can it break in half in two days just driving arount town
Yes any Storm motor will fit in any storm, however you will also need the wiring harness from the new engine if it is not the IDENTICAL motor. You will also then need the ECM. Storm Motors Include 1.6 SOHC 12v (90-93 Base Model) 1.6 DOHC 16v (90-91 GSi) 1.8 DOHC 16v (92-93 GSi) Sources... www.isuzone.org www.stormowners.com
YES, IT WILL IT WILL FIT IN THERE PERFECTLY WITH NO PROBLEMS AT ALL! I HAVE BEEN CHANGING GEO ENGINES FOR 25 YEARS I HAVE PUT A 89 GEO TRACKER ENGINE INTO 91 GEO STORMS LOTS OF TIMES. WHEN CHANGING ENGINES ALWAYS CHECK YOUR MUFFLER BELTS AND MAKE SURE YOU HAVE PLENTY OF OIL, TRANSMISSION FLUID, BLINKER FLUID, AND REAR END OIL. ALWAYS CHECK YOUR SEALS ALSO. SINCERELY CHUCK DAVIS
If 8th digit in each cars VIN are the same, then yes!
Yes, that is how they are made
well i have a geo metro and i have a 3 cil in mine but they put a 4 cil in the 90s The Geo Metro is made by Suzuki. The Geo Prizm is made by Toyota and is built in California on the Corolla chassis. The 1992 Geo Prizm has a Toyota 1.6 Liter 4 cylinder. Base engine is 102 H.P. GSi engine is the same 1.6 but with 130 H.P.
Yes, not a problem. Any unfit components swap it from your old engine.
the clutch is really easy to install and the timing belt is not a problem if its shot The 1993 Geo Storm is not an interference motor, because my belt just broke,(Nov 2005) and I got the same question answered on the following website: "www.nutzandboltz.org". My daughter's 1990 Geo Storm timing belt broke while she was driving it. She tried to start the engine but it would not run. We were told that it was an interference motor and that the motor was now shot. Being a little skeptical of the "experts" I put a new timing belt on and the engine started and has run fine for several months (clutch just went out). So much for the experts, by the way how ard is it to change the clutch? Thanks M in Omaha
all you do is pull on the cover and it comes right out and when you put cover back on it snaps right back in
6.1L Hemi
V10 - Dodge Tomahawk