Want this question answered?
Usually 3/8, but it's ok to step up to 7/16.
what transmission is in it?? turbo 350??? My 82 firebird has roughly the same size torque converter and should hold around 4 liters. make sure you flip the torque converter on its side after you put some in so it drains into the sides of the converter, put another liter in and do the same. if you have any other questions email me at aka_sparxxx@hotmail.com
Consult the converter manufacturer of your choice for a recommendation based on your application.
What size is the starter bolt on 6.5 turbo diesel starter?
3/8-16x1 1/4
which bolts are you talking about? every different size bolt has a different torque spec.
If you mean a bolt with a head size of 24mm (M16) then the recommended torque setting will be 210Nm but if you mean a head size of 36mm (M24) then the recommended setting will be 710Nm.
The rod torque on a Chevy 350 V8 depends on which size rod bolt you have. On the 3/8 rod bolt the torque is 45 ft/lbs On the 11/32 rod bolt the torque is 35 ft/lbs
97 buick lesabre center front wheel bolt size
caliper bolt size 2007 Honda odysey
I believe the torque is figured on the bolt size, not the material. you are using steel bolts ,therefore the torque for an intake bolt on a sm. block is 20 ft. lbs.
It is not really answerable, depends on many factors. Bolt size thread pitch of the bolt material the bolt is made of that material the bolt is screwed into lubricated/unlubricated and what with what it was initially torqued to If you have Snap on tech100/250 torque wrench it will give you a final torque #, I have seen torque readings double the intial torque # after the 90 degrees.