0
What is the bolt torque for flex plate for a 6 liter Chevy engine?
Wiki User
∙ 6y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How can you determine year of a engine Chevy 350 5.7 liter Are there ID numbers or a plate on the engine block?
there should be a numbered stamped on the rear of the engine
2003 Chevy Tracker 2.0 liter crank sensor location?
on back of engine behind the flex plate.
Where is the fuel pressure regulator on a 2001 Chevy silverado 2500hd 8.1 liter engine?
under the plastic plate covering the engine. Right hand side
Where are the spark plugs located on a 1998 Chevy Malibu?
on top of the engine under 2.4 liter stamp remove the 4 bolt on heat plate and there they are
What is the torque specs for the pressure plate to fly wheel on 2003 Chevy s-10 2.2 engine?
The torque specs for the pressure plate should be torqued to 55 ft. pounds in a criss-cross pattern. A non-hardening thread locker should also be applied to the threads of the fly wheel on a 2003 Chevy S-10.
What is the torque spec for clutch plate Chevy 1997 S10?
1997 S10 4 cylinder engine pressure plate to flywheel bolts, 33 ft lbs.1997 S10 V6 engine pressure plate to flywheel bolts, 29 ft lbs.
Pressure plate torque specification for Chevy 350?
In 1970, the rating was 35ft/lbs.
Does the torque converter have to be removed to change out a transmissions on 2001 Chevy X Z?
It must be unbolted from the engine flex-plate (flywheel) then correctly installed into the replacement transmission. Failure to install the torque converter correctly will result in expensive damage to the transmission.
Where is the spacer plate on a 99 ford explorer?
between torque converter and engine
What is the flex plate on your 1997 Plymouth Breeze?
It is the ring gear and plate that conects your engine and automatic transmission's torque converter.
How many bolts hold a chevy transmission in?
Generally there is six bolts holding the transmission bellhousing to the engine block. There are several more holding the torque converter to the flex plate and the rear transmission mount to the crossmember.
What is the torque spec for flywheel for Chevy S-10?
few websites i have searched have come back with a flywheel to crankshaft torque spec of 50 ft-lbs same goes for the flex plate in automatic models. pressure plate torque spec is 23 ft-lbs
