brake bleeding sequence for 1999 Chrysler is as follows: with engine off start with right rear 4 times then left rear same 4 times then right front 4 times then left front 4 times simple
On your brake peddle there is a switch it is either bad or stuck, most likely.
The price of brakes lines for 1999 Chrysler Cirrus LXI vary depending on the seller. They can range from 30 to 50 dollars as of 2014.
Under the hood, driver side, near the base of the windshield.
You take the cap off of the master cylinder and pour it in.
on the brake pedal bracket there is an acuator it may be adjustable or you may need to replace it
Brakes are adjusted too tight. Brakes are misassembled. Brake hose is restricted, holdings the brake on.
It goes into the reservoir that is on the far driver side under the hood. It is located close to the bottom of the windshield.
in the fuse panel unde the dash look for st lmp(stop lamp)
Could be any of a number of reasons !... Faulty bulb, broken wire, dirty contact....
There is no sequence, But it is common practice to start with the caliper closest to the master cylinder and work out.
Front Right, Front Left, Rear Right, Rear Left.
For left hand drive cars, the sequence is right rear, left rear, right front, and finally left front.