The choke lever should be down for the choke to be off. In the raised position is choke on.
choke lever pushed downwards = choke on
Standard is full choke first, then half-choke for a couple of minutes, then run.
The correct spark plug gap for a 84 suzuki lt50 is 0.028 this is the factory spec.
Depends on the saw... On a Stihl chainsaw there is a four position switch. Top position is OFF, second position is RUN/IDLE, third position is HALF CHOKE and the last position is FULL CHOKE. Hold the throttle in with your finger and move the switch down with your thumb. DO NOT try to move the switch down into choke WITHOUT holding in the throttle. On a Husqvarna chainsaw there is normally a switch that you pull out towards you. However, there have been models made that you have to push a switch downwards.
yes
Yes.
ngk bpr4HS
Just to the right of the LH grip you have rotating choke lever. All the way up is no choke, Rotated all the way down is fully choked.
i have one myself, up is off, down is on
COLD ENGINE STARTING OR STARTING AFTER REFUELING --Set unit on a flat surface. --Slowly press the primer bulb 6 times. --Move choke lever to FULL CHOKE position. --Squeeze the throttle trigger fully and hold through all remaining steps. --Pull starter rope handle sharply 6 times. --Move choke lever to HALF CHOKE position. --Pull starter rope handle no more than 6 pulls, until engine runs. --Allow engine to run 10 seconds, then move choke lever to OFF CHOKE position. RESTARTING A WARM ENGINE --Move choke lever to OFF CHOKE position. --Pull starter rope handle until engine runs. --If engine does not start in 5 pulls, follow instructions in STARTING A COLD ENGINE.
The function of the input choke for an AC drive is much the same as the function of the choke on any other mechanical device. The jump start the unit the choke should be in the open mode. The stop the operation of the unit the choke should be moved to the closed position.