0
Standard is full choke first, then half-choke for a couple of minutes, then run.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What is the input choke used for AC drive. What is its function?
The function of the input choke for an AC drive is much the same as the function of the choke on any other mechanical device. The jump start the unit the choke should be in the open mode. The stop the operation of the unit the choke should be moved to the closed position.
How do you start a Harley Davidson 883 sportster?
turn key to start position, put bike in neutral, ( one position up from first gear), neutral light should light and push start button. If engine is cold pull out choke cable on left side.
How do you start a McCulloch chainsaw?
Don't know what model you have but mine starts this way: start switch to on ..throttle in lock start position..choke out...pull three times...push choke in and pull to start...mine starts every time this way...
I can start THE car after setting over nigth. after it runs and you shut it off it won't start again 1981 280z?
Your choke may be stuck in the closed position , there for after the car is warm it want start because it no longer requires the choke . It's something to check .
How do you start an ATV?
make sure its in neutral, set hand brake and turn the key to on position and press start buttun. you may have to set the choke
How do you start a Weed eater Featherlite?
COLD ENGINE STARTING OR STARTING AFTER REFUELING --Set unit on a flat surface. --Slowly press the primer bulb 6 times. --Move choke lever to FULL CHOKE position. --Squeeze the throttle trigger fully and hold through all remaining steps. --Pull starter rope handle sharply 6 times. --Move choke lever to HALF CHOKE position. --Pull starter rope handle no more than 6 pulls, until engine runs. --Allow engine to run 10 seconds, then move choke lever to OFF CHOKE position. RESTARTING A WARM ENGINE --Move choke lever to OFF CHOKE position. --Pull starter rope handle until engine runs. --If engine does not start in 5 pulls, follow instructions in STARTING A COLD ENGINE.
85 Chevy 350 wont start with choke?
does it start without the choke? if it does you are probably flooding the engine with the choke readjust it
Why would a 2 cycle engine not start?
== == Basically, the problem is often that, the choke being left "on" continually prevents the engine from starting because there is too much gas for the air being provided. (The choke control reduces the air being provided to burn with gas). On warm days, a two-cycle engine does not need to be choked very much. The cooler it is, the longer you need to leave the choke on. You need to prime the engine by pushing in on the plastic dome that you can see gas in. That sends gasoline into the fuel line. Five pumps or so is all you need. Be sure that the cut-off switch is turned to "run". Put the choke lever into "choke on" position. Pull the start cord twice. That normally provides a good gas/air mixture to the cylinder. If the engine starts, put the choke lever back into the "choke off" position after a few seconds, and let the engine warm up. If it starts to sputter, put the choke back on for a few seconds more. If it doesn't start, put the choke lever back in the "choke off" position. (Yes, even if the engine does not start). Continue to pull the starter cord several more times. then put the choke lever back to "choke on" if it still won't start and start the cycle again.
What could some of the reasons be that a 1988 Ford Ranger will not start when it is cold outside?
First I would make sure the basics are covered; new plugs, good wires,cap,and rotor. When this is done and it still starts hard, spray a little gas in the carb to see if that helps; if it does,then carb/fuel delivery needs to be looked at. On carb-equipped trucks,the choke should be closed at start-up and then the choke pull-off ( the pull-off has a vaccum line on it,and is attached to the choke blade)should open the blade about 1/16" at start-up. Once the truck starts, the choke should open fully after it reaches operating temperature.The choke thermostat may be bad keeping the choke open and not closing.When you take your air cleaner off,the choke should be closed tight; if it is slightly open this may be your problem. I hope this helps you. Mark
Why would a 1980 Blmc mini start with some effort then as soon as you give it some gas it sputters and dies in and out?
If this car has a choke then it stuck in the open position.
When you start your car at any time it is always over revving it is an ford galaxy automatic?
Either the idle is adjusted to high or the cam on the choke is stuck in the closed position
How do you start your riding lawn mower with a chokeWhere is the choke?
The choke on a riding lawnmower is typically a lever on the "dashboard." Often it is near the lock. The choke is used primarily when starting a riding mower that is cold and often it is not necessary to use the choke after the engine has been running. The choke, when engaged, allows more fuel and less air to reach the spark plug in the engine. The higher concentration of fuel is easier to ignite and thus the engine is easier to start. Once the engine is running and warm, the choke should be disengaged.
