red is 12 volt
yellow is memorey
black is the ground
blue is the power antenna
orange is the ullumination
gray is rt front +
gray-black right-
white lt front +
white-black lt front -
violet rt rear+
violet-black rt rear-
green lt rear+
green-black lt rear-
The wiring diagram for the Kenwood Excelon can be found in its service manual. This service manual can be obtained from Kenwood upon inquiry.
You mean where can i find the wiring diagram.
Wiring diagram for instalation
I will try to make this as simple as possible starting with the tools you will need. Phillips Head screw driver or cordless drill Pointy nose plyers and wire stripper Soldering iron and solder Something to test your wiring to see which one has power Heat shielding or electrical tape I think that's it! The red wire is normally power and the black ground, the speakers are something you can work out by sound or looking at the speakers they are connected to. The kenwood will come with a harness that plugs in the back of the steroe, the ford harness will not fit the kenwood so you will have to cut the ford harness (not to short from the plug) and then solder the kenwood harness on to it. Hope that helps.
The wiring harness can be purchased from partsstore.com or a Kenwood Parts Distributor (1-800-421-5080) for $19.62. If you're missing the wired remote you're in more expensive trouble. It cost around $94.16 to replace and in my opinion is way too expensive to replace when a complete subwoofer with accessories can be ordered for less off of ebay. Good Luck!
kenwood car stereo kdc-mp528 wiring diagrahm
There is a wiring harness most everywhere you look on that and any vehicle. Be more specific.
The purpose of the wiring harness is to help keep wires together instead of hanging freely. You can purchase a new wiring harness at any auto repair shop.
The wiring harness can be removed by unplugging all of the wires. The wiring harness is also held in place by several retaining screws. Remove the retaining screws.
The factory wiring harness for the trailers will plug in under the back of the vehicle in the area of the spare tire, the harness plugs into the wiring harness for the tail lights.
It depends on which Harness you are looking for.
the harness