0
What is the command to change the default interval between Hello packets?
Wiki User
∙ 9y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the default interval for how often Hello packets are sent out and can you change the default settings?
The default interval for Hello packets to be sent out is 5 seconds. Yes, the default settings can be changed by entering "IP HELLO_INTERVAL EIGRP" on the command line.
What is the hello interval?
The 'hello interval' is the time between hello packets, set in seconds as a parameter between two numbers, in OSPF routing timer protocols. The hello interval is the contacting-hello exchange between point A and Point B in computing, where a message is sent via an interface to a website or other computer point and returned to the user. Read about configuring routing timers for 'hello interval' and 'dead interval'.
What is the purpose of the default route?
it is where the router sends all packets with destination of which it has knowledge.
What does the ping 192.168.0.1 -l 1000 -n 100 command do?
The ping command will send roundtrip packets to a destination ( other PC, router, printer, etc. ) and see how long it takes. The 192.168.0.1 is the destination ( which, by the way is a typical default IP address of a router. ) The -l 1000 is how big the packet should be in bytes. The default is 32, if the -l parameter is not used. And the -n 100 is saying to send it 100 times. The default is 4, when this parameter is not used.
What is a router on the local network that is used to deliver packets to a remote network?
Default gateway
What command would you use to send packets to another computer?
Ping
What command would you run from a windows command line to verify that a nic can send and receive ipv4 packets?
ping 127.0.0.1
Difference between 802.2 and 802.3 packets?
.1 packets
When would a PC need a default gateway address?
You would only need a default gateway address if you wanted to route packets outside your local area network.
What is the ping command to send 8 packets as a test?
ping -n 8 destination
What is the difference between an ultimate route and a default route?
A default route is considered a gateway of last resort; meaning all ip packets that don't have a match in the routing table of a router will be forwarded to the default route. An ultimate route is a route in the routing table of a router that indicates both the next hop ip address and the exit interface.
How do you hack smoothwall?
1) Start 2) Run 3) Cmd or Command Prompt 4) Type ipconfig /all 5) Write down Default Gateway (i.p. for Smoothwall) 6) Inject packets of information into it, or block it with an I.P. blocker
