The engine block was Yellow, the valve covers were Argent, the air cleaner was Black, and all accessories were Black. Transmission was Black as far as I know, but I am not 100% sure on the transmission color.
AX5
The 85 had a 305 as an option....so yes. It will fit. However, the computer and possibly the transmission will have to be replaced. The motor mounts will also have to be moved to the correct location....which should already be drilled in the frame.
Crankcase or motor oil is thicker than transmission oil. That's one difference, there may be more (other than color)
It would take a whole new engine.You can fit a Corvette engine in the engine bay. It's all in having the correct motor mounts and proper transmission fitment.
It slides over the transmission shaft that goes into the pilot bearing on the back of the motor. The transmission must come out and then you can access the slave cylinder which will be held on by a couple bolts. Once the transmission is out the slave cylinder (which most of the time comes with a new throw out bearing) will be easy to replace. Its not too bad of a job.
if its the 2.4 liter its the exact same motor so yes, this would be possible
The correct answer is twoBUTThere is a rear transmission mount as well to support the engine and transmission assembly properly.
the recent variations of the 3.9 v6 magnum , the 5.2 and 5.9 v8 magnums are all the same bolt pattern.
The clutch slave cylinder is probably at fault. Replacement is necessary to fix problem. Transmission must be removed to gain access to the slave cylinder.
It all depends on the vehicle as to how easy it is, but the slave cylinder is in the bell housing of your transmission. The transmission needs to be dropped and the slave cylinder isn't hard to remove after that. The biggest task would be disconnecting/removing the transmission and then aligning it correctly upon replacing it. (ex. don't get any wiring, etc. caught between bellhousing and motor, get all bolts tightened and threaded properly) It is a cylindrical (hence the name)peice that attaches to the transmission where it connects to the motor. .
you can install an automatic transmission, but i wouldn't try one from a v6 unless your motor is a v6 as well
A standard 5 speed manual is an AX 15.