All bumper jack bases were painted blue and measured 6 x 6". Two different part numbers could have been used for the rack. 9783363 (keystone shape) or 9781295(square shape). The handle was the same for '64-'67, Part # 9775167 . It was blue and doubled as a lugnut wrench. It had a rubber sleeve # 9785869 in '66 and '67 only. The 5 1/2" bolt that secured the jack was unfinished metal (part # 535782 ) as was the wing nut (9785616).
A lumber jack?I don't a bumper jack but I will tell you whats a lumber jack is.It is a person who cuts down trees.
the bumper jack goes under the back bumper, there might be slots on each side of the rear bumper to put the jack into.
InstructionsLift the rear of the Corolla using a floor jack. Jack up on the rear jack point behind the trunk, and place a jack stand under each of the rear pinch welds. Then lower the vehicle onto the jack stands.Pry the plastic rivets off the inner wheel liner with a flat-head screwdriver.Remove the bolts that hold the bumper to the bumper bracket and support.Pull the bumper off the bumper support.Mount the new bumper. Align the mounting holes on the back of the bumper's mounting bracket with the bumper support, and thread and tighten the bumper. Replace the plastic rivets that hold the wheel liner to the rear bumper.Remove the jack stands, and lower the car.
Jack Train died in 1966.
Loosen the mounting bolts, there should be four of them then place a jack under the bumper and jack the bumper up until straight or even then tighten the bolts.
no
"The vehicle's bumper jack is located in the storage compartment, beneath the trunk floor." -That's from the 2006 SLK owner's manual.
The Jack Benny Hour - 1966 TV was released on: USA: 1 December 1966
floor or bumper jack
Jack Rush was born in 1966.
Jack Loutet died in 1966.
Jack Tully died in 1966.