0
"The vehicle's bumper jack is located in the storage compartment, beneath the trunk floor." -That's from the 2006 SLK owner's manual.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where is aux jack in 2006 Mercedes Benz c230?
where can find the phone jack in 2006 mercedes benz c230 thanks
How do you remove 2006 Toyota corolla rear bumper?
InstructionsLift the rear of the Corolla using a floor jack. Jack up on the rear jack point behind the trunk, and place a jack stand under each of the rear pinch welds. Then lower the vehicle onto the jack stands.Pry the plastic rivets off the inner wheel liner with a flat-head screwdriver.Remove the bolts that hold the bumper to the bumper bracket and support.Pull the bumper off the bumper support.Mount the new bumper. Align the mounting holes on the back of the bumper's mounting bracket with the bumper support, and thread and tighten the bumper. Replace the plastic rivets that hold the wheel liner to the rear bumper.Remove the jack stands, and lower the car.
Where is the aux jack on 2006 Mercedes e350?
In your glove box , it should be at the very top .
Where is the Jack on a 2006 Chrysler Pacifica?
In the little storage area in back...lift up the molded carpet panel. The jack is on the left going toward the bumper.
What is a bumper jack?
A lumber jack?I don't a bumper jack but I will tell you whats a lumber jack is.It is a person who cuts down trees.
Where do you place a jack to jack up the back end of a 1972 Dodge Dart Swinger special?
the bumper jack goes under the back bumper, there might be slots on each side of the rear bumper to put the jack into.
How do you fix front bumper if it is bending downwards on a Mazda b2300 1996?
Loosen the mounting bolts, there should be four of them then place a jack under the bumper and jack the bumper up until straight or even then tighten the bolts.
Would a bumper jack be a third class lever?
no
Does the Mercedes c180 kompressor have an aux jack?
no it does not
How do you get a riding lawn mower off blocks?
floor or bumper jack
How do you remove the front bumper on a 2004 dodge Dakota?
Support the bumper with a jack or jackstandWith an assistant supporting the bumper remove the bolts/nuts retaining the bumper to the frameRemove the inner bumper bracket mounting bolts and the push-in fastners securing the air deflector to the bottom of the bumper fasciaDisconnect any wiring harnesses that would interfere with bumper removal and detach the bumper
How do you use a 1983 ford bumper jack?
The bumper jack has 3 pieces. The base (square and black) sits on the ground and the jack sits in the base, it won't stand up by itself, it falls over. On the jack head is a grey hook. On the car in each corner (right beside the black bumper pad) is a small 1 inch cut out for the jack hook to hook into, you may have to look under the bumper to see these cut outs. slide the jack and the base under the bumper and lift the jack head into that notch, sometimes they slide up and sometimes you have to "jack" them up into position. The lug wrench handle is designed to fit into the jack and allow you to jack the car. On the jack head there is a lever that says 'down' flip the lever up and move the handle up and down to ratchet the car up, it takes a good ammount of force once the car gets up. Once you are done flip the lever down and ratchet the handle again to lower. When lowering you must push the handle down pretty hard to activate the ratchet function. It's primative but I found it very effective in lifting this heavy car.
