There are a flat head nuts on the back side of the bummer, you will need to remove these nuts then pull the bolts out. the bumper (if it has not already done so) the bumper will fall off. If you also wish to remove the braces you can do so just as easily.
Unbolt the front of the wheel well liner inside the wheel opening.Remove the bumper cover bolt from the bracket located inside of the bumper at the end.AT the front of the car, remove the bolts holding the bumper cover on, located underneath the vehicle.You should now be able to remove the bumper cover from the front of your Dodge Intrepid.An instructional video has been included to show you the removal process.
You have to have a little mechanic ability to unbolt them and reinstall them. ^^^^that is a given, here is a step by step instruction on how to remove the bumper on a Dodge Dakota 98-99 (i'm sure it's the same for a few other years mainly generation 2 Dakota's), and a list of tools needed. Tools needed: 18 mm Socket and a ratchet WD-40/PB Blaster #2 Phillips bit screwdriver / flat head (in order to remove bumper cover) how to remove the bumper: 1.) pop your hood and open it all the way 2.) look down in front of your coolant overflow tank and just to the left of the radiator 3.) remove the four 18mm bolts from bumper 4.) pull bumper out (if you need to remove the brakets that the bumper is bolted to then you need a T50 star bit and a 3/4 inch socket with a 6" extention)
how to remove front bumper 2002 Impala
how to remove front bumper on citroen berlingo
While this link is for the front quarter panel removal instructions, there is a part that requires the removal of the front bumper as well... Hope it helps: http://www.carboneracing.com/fender.html
you need a socket set with an extension 1. open the hood 2. located the 4 bolts holding on the bumper just in front of the radiator 3. remove one bolt from each side 4. have a friend hold one side of the bumper while you remove the last 2 bolts having a friend there is important cuz dak bumpers are oddly weighted and hard to carry by your self
Haynes repair manual, Dodge Neon 2000 thru 2003. Book #30036
Quite simply YES. The fog lights may be different. I replaced my 2003 factory front and rear covers with painted ones from my 1998 Dakota
For the 98 it is right behind the front bumper between the driver side headlight and the radiator. Sorry if this doesn't help.
you have to remove trans.after trans is removed remove tork.conv.check bushing in front pump you will find that it is bad
# Support bumper with a jack or jackstand # With an assistant supporting the bumper remove the bolts,nuts and stud plates retaining the bumper to the frame # Disconnect any ireing harnesses or any other components that would interfere and detach the bumper