answersLogoWhite

0


Best Answer

They are two different sizes and should be color coded

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the correct plumbing for the fuel lines. Tank to filter to pump 1986 bronco 302 EFI. There are 2 lines into the filter and 2 lines out which is which?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the correct grade of toilet plumbing lines to septic system?

1/8th of an inch per foot


Where is the fuel filter on a 1995 ford bronco?

Under the driver side, against the frame, follow the fuel lines from your tank, you can't miss it.


How do you replace a fuel filter on an Infiniti qx4?

follow fuel lines to filter. remove lines from filter and fit lines to new filter.


What are the 3 Plumbing lines connected in the middle for?

A union


How do you change the fuel filter on a 2000 Infiniti I30?

trace fuel lines to filter, disconnect lines from filter, fit lines to new filter


What size brake lines on a bronco ii?

3/16"


What are the release dates for MuscleCar - 2001 Trans Am Lines and Hoses and Overkill Plumbing?

MuscleCar - 2001 Trans Am Lines and Hoses and Overkill Plumbing was released on: USA: January 2009


How do you replace a fuel filter on the Infiniti G20?

separate the lines from the filter and fit the lines onto the new filter. just trace the fuel lines to find the filter


What is house plumbing?

Water, drain, and vent lines that are used to plumb a house.


Can PVC irrigation pipe be used for culinary lines?

Not in most civilized plumbing codes


What kind of plumbing pipes were used in 1955?

Galvanized pipe for water and drain lines. Cast iron pipe for main drain lines.


What are plumbing Rough-in stops?

Roughed-in plumbing refers to plumbing (water and waste lines) installed for future fixtures, for example, a bathroom in a basement. Stops refer to shut-off valves on water supply lines, required to shut-off the water to repair the fixture that they service. So "Rough-in stops" are shut-off valves on supply lines that are roughed-in. If they were not roughed-in, you would need to break concrete floor (to install waste lines) if/when you decided to add a bathroom to your basement family room.