An accessory belt is any belt that drives additional power systems from the front crank of an engine. Typically, these "accessories" are the alternator, Power Steering pump, and air conditioning compressor. In many rear wheel drive vehicles, a belt is also used to drive the radiator fan. Typically called "V-belts," they are so named because of their wedge shaped cross section that grips the groove in the drive pulleys.
A serpentine belt is a particular kind of accessory belt design that drives all of the accessories with a single belt. It does this by winding a serpentine course around all the pulleys. Serpentine belts are wider and flatter than V-belts, and grip the pulleys with multiple shallow grooves.
Serpentine belts are considered the best contemporary solution to accessory drive requirements, as they require less engine compartments space, reduce design complexity, and are easier to change. On the down side, if they fail, you have a major problem, as all your auxiliary systems will fail at once. For this reason, they are manufactured to much higher standards, and are correspondingly more expensive.
No, an accessory belt is not considered a serpentine belt. However, a serpentine belt is considered a specific type of accessory belt.
The serpentine belt would be the same as the accessory drive belt.
Accessory belt
Accessory drive belt.Accessory drive belt.
It could be but the accessory belt could also be a v-belt type belt.
V Belt and Serpentine Belt.
he serpentine, or accessory belt.
The timing belt is driven by the crank and turns the camshaft. The serpentine belt drives the alternator, air conditioning, power steering, etc.
Depending on how many miles are on your vehicle. If you have 35k or more you need to replace your serpentine belt or all of your accessory belts. And if you have 89k or more you need to replace your serpentine or accessory belts and your timing belt.
it could be a serpentine belt or accessory belt.
To remove the accessory drive belt or the serpentine belt from the motor on a 1989 Sunbird, it is necessary to loosen the belt tensioner. Look for a pulley that has a bolt in a slot. Loosen the bolt and move the tensioner so there is a gap in the belt. Then remove the belt from each pulley.
Serpentine belt, accessory drive belt.