Stepped hat rotors are more expensive than plain hat rotors. A stepped hat rotor has a groove in it, known as a heat break or heat shield, that helps distribute the heat away from the hub assembly, reducing the risk of brake failure. This is normally used in cars and trucks that will be towing or doing heavy duty work.
There is no difference between brakes and rotors because the rotor is just one of the many parts that make up a brake. The function of a brake rotor is to stop the wheels from spinning. The rotor is what the brake clamps hold on to stop the car.
Ceramic pads are much harder, last longer. However not compatible with all rotors, ask your brake technician at local shop.
Yes. It does not make a difference whether is is the conventional, slotted or drilled rotors. They can all be machined in a brake lathe with the same accurate result.
Brake rotors wear because during use, brake pads are pushed against them while the rotors are turning. It's the friction between the moving part and the staationary part that slows the vehicle down. Pads wear too, usually quicker. Brake rotors wear due to use, they are considered a service item.
2 wheel or 4 wheel drive, front or rear rotors, it makes a big difference.
There should be two rotors if your truck is 2wd. They are located where the brake pads clamp to. Rotors are also called brake disc. It's the round disc between the brake pads.
Brake calipers are the hydraulic devices that wrap around the rotors and pinch the brake pads into the rotors when you stop.
You can get your brake rotors replaced by visiting Autoparts Warehouse which contain various brake rotors in size and durability to fit your needs and accommodate your budget.
Excessive or heavy and continuous braking may warp brake rotors. Braking hard (heating the rotors a lot) and then going through water (which quickly cools the hot rotors) may also cause the rotors to warp. If the brake pads or brake rotors are getting thin, the rotors will warp more easily.
A brake lathe is a metal lathe designed for truing the surfaces of automotive brake rotors which the brake pads bear upon.resurface rotors and drums
If you are wondering whether it is possible to replace one's own brake rotors or not because you drive an older vehicle that need brake rotors replaced, then the answer is no.
Brembo brake rotors have been reported as being good brake rotors, they are pretty reliable, and durable. You can find out more information about them at the Brembo website.