Starters and Ignition Systems
Ford Explorer Eddie Bauer
Ford Festiva

What is the exact location of the ignition control module on a 1993 Ford Festiva?

515253

Top Answer
User Avatar
Wiki User
2005-04-25 20:04:58
2005-04-25 20:04:58

Here is a page from google i visited about the module in question. http://www.ncf.ca/~ag384/IgnitionModule.htm

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

I'm working on a 1987 Festiva, and I *believe* that this is located inside the distributor housing.

User Avatar

You can find the Ford Focus ignition control module beneath the drivers side dashboard. The ignition control module will be above the accelerator pedal.

User Avatar

the ignition control module is operated by the pcm,the pcm tells the ignition control module when to energize the coils to enable spark

User Avatar

The 1994 Ford Aerostar ignition control module is located on the firewall in the engine compartment. The ignition control module will be on the drivers side of the firewall.

User Avatar

The ignition control module on a 2000 Blazer with the 4.3 is mounted on the same bracket that the coil is mounted to.

User Avatar

Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.

User Avatar

The engine computer is also the ignition module.

User Avatar

The computer module, or ignition control module, is locate on the left inner fender.

User Avatar

The ignition control module sit directly below the distributor.

User Avatar

Where is the ignition control module located in my 1992 Crown Victoria

User Avatar

The engine computer, next to the battery, is the ignition module.

User Avatar

ignition control module is under the distributor cap

User Avatar

Where is the place of the canshaft position sensor in1998 xk8

User Avatar

Where is ignition control module on a 2001 mercury sable

User Avatar

Only the EEC-IV ignition systems ( 1991 to 1995) use an external ICM (ignition control module) . From 1996 on with the EEC-V system the ignition control module is incorperated into the power control module (PCM) mounted in your firewall on the passenger side.

User Avatar

A Mercedes-Benz 300SE ignition control module can be obtained from most Mercedes-Benz dealerships. The ignition control module, can be purchased at most auto-parts stores.

User Avatar

The ignition switch is part of the WCM (wireless control module).The ignition switch is part of the WCM (wireless control module).

User Avatar

where is the ignition control module loacted on a 1997 chevy cavalier

User Avatar

THE IGNITION CONTROL MODULE can be at two locations one is mounted right near the distrubutor the other location is on the drivers side fender behind the battery.........corey

User Avatar

The 1990 Chevy Celebrity engine is distributorless, the ignition is handled by a combination of the engine control module(computer) and the ignition control module. You did not mention which engine the car has. If your car has the 4 cylinder engine the ignition control module is below the intake manifold at the rear of the engine. You can follow the spark plug wires to it. The coils are mounted to the ignition control module. If your car has the V6 the ignition control module is near the starter and again you can follow the spark plug wires to it. Again the coils are mounted to the ignition control module.

User Avatar

Disconnect the battery. Remove the ignition coils. Remove the ignition control module that was under the coils, and replace it.

User Avatar

where is the ignition control module on a 1995 Pontiac Transport and how do i replace it


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.