Want this question answered?
70 inches RO framing is 69" plus 1/2" drywall on either side will put you at 70" finished. This gives you a 2" over lap on the doors. Alex DenverInteriorDoors.com
32 inch. 36 is too hard to close from a wheel chair.
4 inch in the dash 6 inch in doors and back 4 inch in the dash 6 inch in doors and back
36 inches IS the width. . .normally doors come in 24, 28, 32, or 36 inch widths, and either 6'8" or 8' height
If you are talking about the depth being 40"...you may want to try turning the sofa on its side as you walk it through the opening.. standard doors are 30" to 36" wide.
Play it safe and allow 32", Bi-folds come with light frames and will probably only require a 31 1/4 inch opening, but it's a lot easier to "pad out" or "shim" the frame then it is to open it up wider.
The speakers in the doors of a 1991 Ford Ranger are 6-inch speakers.
Add two inches to height and width. So a 36 x 80 door roughed out is 38 x82. This is with doors only. Windows you add 1 inch to the height and width.
6.5 Inch in the front doors and 5x7 Inch on the sides of the rear seat.
You can convert a deep well jet pump to a shallow well jet pump by plugging the top three quarter inch opening, and drawing water in through the bottom one and a quarter inch opening.
no no
Dash-3 inch. Front doors-3.5 or aka 3 1/2 inch. Rear 6x9 inch