0
go see the doctor and tell him you have swallowd it :p
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What effect does hygroscopic have on the brake fluid?
If your brake fluid is hygroscopic then it means that is will absorb water/moisture from the air and it can effect your boiling point and your brakes may fail at high speeds.
What is the effect of brake fluid on plants?
Typically brake fluid is a petroleum base, so one drop won't typically hurt them but if emersed it will kill them.
What happens when you run out of brake fluid?
The brake pedal will go to the floor but will have absolutely no effect on stopping the vehicle. When you push on the brake pedal it moves the fluid through metal tubes (called brake lines) to force the brake pads against the rotor which slows and stops the car. No fluid means nothing is in there to make the brake pads engage the rotors.
What should you do if you accidentally poured washer fluid instead of brake fluid in the brake reservoir?
The first thing you should do is remove the master cylinder so you can dump the brake fluid reservoir out. If you have used the brakes, it is a very good idea to get the entire brake system bled and replace all the brake fluid.
Where do you put clutch fluid in a 1995 ford escort?
It uses brake fluid in the brake fluid reservoir. The clutch fluid (brake fluid) is fed by the brake fluid reservoir. The clutch fluid reservoir is just beneath the brake fluid reservoir. So, add fluid to the brake fluid reservoir to fill the clutch fluid, also.
How much do you put in brake fluid?
until the first line
Guide to brakes and how to change them.?
Well the first thing that you would want to do is to check your vehicles brake fluid. Typically, if the brake fluid is low then your brake pads probably need to be changed.
Daewoo leganza brake warning light?
This either means that your emergency brake (hand brake) is on, the light switch needs to be fixed, OR (most common) you need to add more brake fluid. Always check your brake fluid first!
Can you mix synthetic brake fluid with normal brake fluid?
Yes. Normal brake fluid is actually synthetic
How do you add brake fluid to a 95 Ford Taurus?
First it must be determined which type of brake fluid a 95 Ford Taurus uses. More than likely it is Dot 3. To add this fluid, find the brake fluid reservoir on the master cylinder. Unscrew the cap to the reservoir and replenish your brake fluid to the fill line. Screw the cap back on.
What kind of brake fluid for 2002 grand am?
It is important to maintain the brake fluid levels in a car. The brake fluid type for a 2002 Grand AM is DOT 3 brake fluid.
Why does the warning brake light go on?
Four Possible reasons... Low brake fluid - check the brake fluid level in the master cylinder Emergency brake is on - check emergency brake Low brake fluid pressure - such as a broken brake line or a bad wheel cylinder. Check the master cylinder to see if it is empty. If you add fluid and pump the pedal you will probably see brake fluid on the ground or on the inside of the tires. Possibly a bad master cylinder. - The fluid will stay full but you will have no or little brake pressure. Could be air in the system as well. BE CAREFUL If you happen to add power steering fluid or transmission fluid to the master cylinder instead of brake fluid you will destroy the system. Make sure you use ONLY brake fluid and clean the master cylinder cap off with a clean rag first so no dirt gets into the braking system.
