around 150-180 Mhz or something around there
because demodulated FM is an audio signal, which the frequency is much smaller that is why it can be transmitted alone. It need carrier which has large frequency. Modulated signal is an audio signal + carrier that is why the amplitude is higher.
The mixer in an AM receiver combines the incoming radio frequency (RF) signal with a local oscillator signal to produce an intermediate frequency (IF) signal. This process allows for easier amplification and filtering of the desired audio signal, as the IF is typically at a lower frequency. The mixer effectively translates the high-frequency AM signal down to a more manageable frequency for further processing, enabling clearer audio reception.
Audio generator will produce some range of frequency and level of a test signal meant for audio. A signal generator will produce a test signal but is a more general classification. For example a audio generator is a signal generator. When you know what type of signal you are looking for, then a signal generator will be called that type of signal. all depends on what you are testing. examples: video -> video signal generator audio -> audio signal generator
1. Start with an oscillator that is controlled by voltage. VCO.2. Use an audio amplifier with limiting3. Apply audio signal to VCO control, usually via varicap diode.The oscillator will change frequency in time with the audio signal.
The frequency f0 in audio signal processing is important because it represents the fundamental frequency of a sound wave. This fundamental frequency determines the pitch of the sound, which is crucial for tasks like music analysis, speech recognition, and sound synthesis.
On AM broadcasts, the amplitude of the carrier wave remains constant. This means that the strength or power of the signal does not change, only the frequency of the signal is modulated to carry the audio information.
To use a spectrum analyzer effectively for audio analysis, first connect the audio source to the analyzer. Set the frequency range and resolution to focus on specific aspects of the audio. Use the analyzer to visualize the frequency spectrum of the audio signal, identifying peaks and patterns. Analyze the data to understand the frequency distribution, harmonics, and any anomalies in the audio signal. Adjust settings as needed to get a clear and detailed analysis.
If the modulation is to large your bandwidth will be to wide in other words the frequency shift will be larger than normal that will result in a distorted audio signal at the receiver
An audio signal is a representation of sound, typically as an electrical voltage. Audio signals have frequencies in the audio frequency range of roughly 20 to 20,000 Hz (the limits of human hearing).
An FM transmitter works by modulating a carrier wave's frequency in accordance with an audio signal. The audio input is converted into an electrical signal, which then alters the frequency of the carrier wave. This modulated wave is transmitted through an antenna, allowing it to be picked up by FM receivers within its range. The receivers demodulate the signal back into audio, enabling sound playback.
FM signals can be detected using a frequency discriminator or a phase-locked loop (PLL) demodulator. The frequency discriminator converts the frequency variations of the FM signal into amplitude variations, which can then be amplified and filtered to recover the original audio signal. In a PLL, the incoming FM signal is compared to a locally generated signal, allowing for the extraction of the original information by tracking the phase differences. Both methods enable effective retrieval of the modulating audio or data signal from the FM carrier.
Amplitude Modulation (AM) is used for the picture portion of a television transmission while Frequency Modulation (FM) is used for the audio portion.