since infrared (IR) is just below the visible spectrum of light in frequency and is radiated strongly by hot bodies......i think so
Infrared transmiter circuit info link.
A The term signify a range of frequency that are either excluded or included as a pass or no pass situation. The frequency are not set to a specific range it just depends when designing what is to be included or excluded for a particular circuit.
When you are trying to detect the presence of any kind of radiation, it is a good idea to use a detector that responds to that particular kind of radiation. For example: If you're looking for radio waves, use a radio. If you're looking for x-rays, use a piece of x-ray film. If you're looking for infrared, use a piece of infrared film, or an infrared diode in a suitable circuit with a horn, a bell, or a visible light for an indicator.
analog circuit is circuit that generates audio, sound, radio etc (waves of the natural world) RF stand for radio frequency, it is often refer to the property of signal transmission in high frequency (HF). If you say a circuit is RF, the circuit would be in the frequency range between 3kHz to 300GHz. The reason that RF circuit is special is because the performance of signals of higher frequency is different to other lower frequency AC circuits. When designing a RF circuit, RF engineers have to consider the type of wires, lengths, use of components, signal loss etc. It is because high frequency signals would take a piece of wire (longer than 1/10 of signal wavelength) as wires with many inductors and capacitors.
printed circuit board printed circuit board
what is resonant frequency
As a parallel resonance circuit only functions on resonant frequency, this type of circuit is also known as an Rejecter Circuit because at resonance, the impedance of the circuit is at its maximum thereby suppressing or rejecting the current whose frequency is equal to its resonant frequency.
when the frequency is increased the total impedance of a series RC circuit is decrease.
1
Can you supply three 220 -240 volt 16.6 amp infrared heaters with one circuit?
requirements
o