Wheel bearing nuts don't have a torque specification as the viscosity of the lubricant
varies enough so the torque number would be nonsense...
Practice has been to snug up the covering nut as tight as possible by standard foot long wrench, so the wheel fails to turn. Then back off 1/8 to 1/4 turn, allowing the wheel to
spin or turn with light pressure..
hope this help / rtd
Using new bolts, torque the front hub/bearing assembly to 96 ft-lbs.....
Remove the tire and wheel from your 2001 Chevy Impala. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing. Reverse the process to install the new front wheel bearing.
What are the torque specs for a 2004 2WD Chevy Tahoe front wheel bearing assembly 5.3 liter engine
Neither, there is no such thing as a 1997 Chevy Impala
front bearing torque 151 ft lb rear bearing torque 63 ft lb plus 36 degrees
Front hub/wheel bearing torque is 190-210Nm.
front
there is no front shaft in 63 impala Wrong answer, it's about two feet from the transmission to the carrier bearing
chevy cobalt torque specfront hub
The nut on the axelshaft is 177 ft. LBS. The 4 bolts on the bearing hub is 133ft. LBS.
185 to 260 ft lbs this is the front center nut that holds axle and front wheel bearing together not wheel lug nuts
Front wheel drive. The last rear wheel drive Impala made was the Impala SS in 1996.