its so that the clamping pressure is the same to get accurate readings, also stops from overtightening and distorting the mic
10+yr Machinist
Yes. The cosine function is continuous. The sine function is also continuous. The tangent function, however, is not continuous.
Yes she is. She is the hottest girl in th world
The function of tang is to fit in the chuck.
The sign function is used to represent the absolute value of a number when used in trigonometry. It is also referred to as the signum function in math.
The functions are periodic and so, given any value (within the range) the function can take the value several times, Graphing the function can help you determine secondary points at which the function takes a given value.
The ratchet is a device which applies a pressure by slipping at a predetermined torque and thus prevents the spindle from moving further.
what is the function of micrometer
ewan ko sa inyo!
Measuring dimensions of small things.
it helps in grappling the object with spindle
the ratchet device is there to provide a calibrated force. the ratchet should always be used because when it clicks it is at the required load for an accurate measurement. without it you could keep turning it tighter and tighter to get any number you want but this won't be correct. it also limits the load on the thread so the micrometer remains accurate for longer
to cheak the diameter of something
First calibrate the micrometer by dialing the spindle to zero and adjusting the anvil until it is flush against the spindle. Measure the screw until the ratchet begins to click and take the first reading. This reading can then be compared to a machining book to verify the pitch diameter.
Micrometer is having a ratchet to rotate which is pre-loaded to get standard thrust while measurement, whereas in the case of a vernier the accuracy of measurement depend on the pressure each individual applying while the measurement.
is like artery forceps but dont have ratchet
First calibrate the micrometer by dialing the spindle to zero and adjusting the anvil until it is flush against the spindle. Measure the screw until the ratchet begins to click and take the first reading. This reading can then be compared to a machining book to verify the pitch diameter.
1 micro meter or 1 millionth of a meter or 1/1000 th of a millimeter - so pretty small