If you have your car manual it should have a diagram of the fuses in the back pages, however the fuse is normally a blue 15amp fuse. if you cannot find the manual it won't take long to check all the fuses. all you do is pull them out 1 by 1 and look between the 2 pins, they should be joined together near the top. if it is broken (melted) separating the pins then the fuse needs replacing. red is 10amp, blue is 15 amp, yellow is 20amp, green is 30 amp. i would be looking for the blue one to start with then move onto the red ones if you don't find it. you should never use a fuse bigger than 20 amps. good luck
*** The fuse for front and rear lighter sockets is number 16/16A which is a two position socket at the top of the box at the rear of the glove box. To get to the rear of the glove box, open it and then depress both metal catches at the side of the glove box until it falls below the normal stopping point. You may need a torch to get a good view of the fuses although the glove box light should be on and will help. The plastic tweezers are quite good for removing the old fuse and are located on the fuse board.
if its the same as a ulysse,its behind the glovebox!
try f29 30amp fuse behind the glove box compartment
Behind the glove box. Just remove it and you'll see it
how do I bleed water system on the 806 peugeot
How do you change fuel filter on peugeot 806 diesel?
Actually there are several different models of the Peugeot 806. The petrol ones are: Peugeot 806 2.0 (here we have two different ones: first one was built from 1994 - 1998 and second one was built from 1998 - 2002) , Peugeot 806 2.0 16V, Peugeot 806 2.0 Turbo (here we have two different ones: first one was built from 1994 - 1998 and second one was built from 1998 - 2002) and finally the Peugeot 806 1.8.
i dont no where the relay is . but the fuse for the instrument panel warning lights is behind the glovebox is f2 and is a 5amp fuse
Your peugeot 806 heater only gives cold airRead more: Your_peugeot_806_heater_only_gives_cold_air_ou
I have been looking for a replacement gearbox for my 2000HDi, found that the 1.9 will not fit.
no
it is impossible
It is on the end of the light stork, just press it...