the ratio is 25 to 1!
No, its bad for your engine Sure you can mix them as long as your vehicle has a flex fuel engine. You can also mix then in a non flex fuel engine as long as you do not mix more than 10% ethanol with plain gasoline.
You do not mix gas and oil in a kawasaki kz 400 motorcycle.
50:1
inboard gas engine exhaust
hydrogen
Looks to be 40:1 gas to oil
Yes, you can. It is even sold as a Synthetic Blend.
Krytox will not mix with engine oil
No, its bad for your engine Sure you can mix them as long as your vehicle has a flex fuel engine. You can also mix then in a non flex fuel engine as long as you do not mix more than 10% ethanol with plain gasoline.
Look on the oil container and the engine that you want to use it in. The engine will tell you what ratio to mix the oil and gas at. The container of oil will tell you what amount of gas should be mixed with it. I have found that the best way is to put the oil into an approved gas can and then add the gas to it. This helps to mix the oil better.
Usually no.
most new push mowers use just regular pump gas. if the engine has a place to check engine oil and has it own oil and filter it is a 4 stroke engine and does not require mix gas. A small engine that requires mix gas (2 stroke) it will be in a 1:25, 1:30, or 1:50 mix of oil and gas. most newer 2-stroke engines use a 1:50 MIX. Look on the fuel cap or see if it is stamped on the engine anywhere. You may need to contact a manufracture to be sure of the mix ratio.
The most that will happen if you put mixed gas in a regular fuel engine is (depends on how much mix is but ) it will smoke out the exhaust and fowl the spark plug or may not run at all.
If the engine has a dip stick or oil fill plug, so that you can check the crankcase oil level, then it is a 4 stroke engine and no oil / gas mix is required.
You will lose all lubrication to the engine, and if you run the engine long enough you will have catostrophic engine failure.
2.6 oz. of 2-cycle engine oil per gallon of gas.
The fuel system on a Briggs and Stratton engine works by fuel being gravity feed from the fuel tank. Fuel goes to the carburetor where air and gas the mix, after the air and fuel mix it is feed into the engine where the engine goes through the four strokes.