Brown.
A disturbed sample is one in which the structure of the soil has been changed sufficiently that tests of structural properties of the soil will not be representative of in-situ conditions, and only properties of the soil grains (e.g., grain size distribution, Atterberg limits, and possibly the water content) can be accurately determined. An undisturbed sample is one where the condition of the soil in the sample is close enough to the conditions of the soil in-situ to allow tests of structural properties of the soil to be used to approximate the properties of the soil in-situ.
clay soil
To check the acidity of the soil and to see at wat level the soil will be able to support life
A soil sample contains living and nonliving materials. Which material was once living?
rock salt
What is the general appearance (color, how loose or compact it is, kind of particles, and so forth) of the original soil sample?
Soil in general does not have any exact chemical composition; this question could be answered in principle only for a particular sample of soil.
The general composition of a soil sample will be some sand, some silt, some clay, and some organic matter, plus a certain amount of microbial life, air and (unless it's completely dried out) some water.
No, a typical soil sample is heterogeneous.
A disturbed sample is one in which the structure of the soil has been changed sufficiently that tests of structural properties of the soil will not be representative of in-situ conditions, and only properties of the soil grains (e.g., grain size distribution, Atterberg limits, and possibly the water content) can be accurately determined. An undisturbed sample is one where the condition of the soil in the sample is close enough to the conditions of the soil in-situ to allow tests of structural properties of the soil to be used to approximate the properties of the soil in-situ.
The soil is still brown and the substance is looser than before.
Very high speed is the best speed to separate a soil sample in a centrifuge.
Porosity is measured by taking a sample of the soil. The sample is then tested to measure the speed of water passing through the soil.
One way is to culture the bacteria on a sterile agar plate with a small sample of the soil. After incubating the sample at about 20 degrees (Celsius) for a couple of days you should be able to see the bacteria, it's normally either a shiny patch or it's a yellowish colour. With soil though, there will most likely be a large amount of fungal growth, which you can identify by it's white, fuzzy appearance.
To neutralise a sample of soil, you must determine the pH of the soil sample either acidic or alkaline. Add lime (e.g. Limestone) to acidic soil to neutralise it. And add sulphur to alkaline soil which will neutralise it.
Iron is magnetic so move a magnet through your soil sample to remove all the iron fillings.
Dirt