I believe that is 15 PSI on a low pressure steam boiler
Raise the pressure in the boiler until the valve relieves and note the pressure at which it does so.
2 times the pressure at which the safety valve is set.
the safety valve is mounted on the top of drum because, if the water level in boiler decreases a certain value, the temperature gets increased in water drum because of lack of water. So, increase in temperature result in high pressure in steam drum, as the safety valve is designed to withstand a certain pressure, after a cetain pressure, the safety valve is removed by high pressure of steam. this is why the safety valve is mounted on top of boiler drum. +++ Shall we sort out that lot? That answer is wrong. Its only link with water-level is that the valve has to be above the water anyway. If the boiler runs dry the safety-valve will not protect it. The safety-valve is there to prevent the steam pressure rising to a potentially a dangerous level. It is set to open at the boiler's designed working pressure.
The lifting pressure is set by turning the adjusting nut on top of the valve.
RUN!
Boiler mountings are different fittings and devices which are necessary for the operation and safety of a boiler .e.g. pressure gauge, safety valves , steam stop valve etc Normally these device are mounted over boiler shell .Boiler Accessories are auxilary plants or parts required for steam boilers for their proper operation and to increase efficiency of the boiler .e.g.feed pumps, super heater , economiser etc
Low water level along with both a defective high limit safety and pressure relief valve.
So the boiler doesn't generate too much pressure and blow up/
the apparatus ( Marcet Boiler ) consist a cylinder surrounded with isolated substance in it electrically heated boiler which is used to heat up water and to measure the both of the temperature and pressure, & it contains thermometer & barometer & safety valve .
when the pressure increases over the maximum allowable working pressure of the vessel, the valve will open to protect against overpressure.
A gagging tool is used on the water drum safety valves for the pressure setting. The safety valves are gagged one by one and the blow off presure is set for the other.
Safety valve simmering how can setting