the clearance of intake valve as far as i know is .18 in.
17mm of the feeler gauge for intake and exhaust valves
the clearance is measured at the top of the bearing with the help of a feeler gauge
The Valve clearance for a 1993 TRX Honda Fourtrax is 0.03 on a feeler gauge. 0.03 -intake 0.03-exhaust
.03 intake .04 exhaust
I believe the clearance should be within .002 and .007 thousands of an inch. and also the end play clearance, should be between .002 and .007. you should check the bearing caps with plastic gauge, and the end play wiyh a feeler gauge.
yes any cluster from 88-95 is interchangible
intake is .002 to .004 exhaust is .006 to .008
tappet clearance gauge 12 but as said by maruti its 13 to 17 when cold I have used 12 and the engine sounds like new pravin
There are several ways.You can:Use a long feeler gauge and see if the piston has clearance in excess of the size, usually you use several in succession to determine clearance to + or - .001 inch or .01 MMUse a Micrometer and bore gauge that have been properly calibrated.There are other ways but those are the most common.
With the thermostat.
The 1995 Ford F3 50 temperature gauge sending unit can be found on the top of the engine. The temperature gauge sending unit will be near the middle of the intake manifold.
if v8 it is in water neck or right behind on intake mantifold /strait 6 water neck or intake on side moter