answersLogoWhite

0


Best Answer

With the thermostat.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you regulate temp gauge Isuzu trooper?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What are the ignition timing specs for a 1988 Isuzu trooper?

12 DEGREES before top dead center at 900 rpm with the egr and purge lines disconnected and plugged and the engine is at operating temp


Why doesn't my RPM gauge and temp gauge work?

why doesn't my rpm gauge and temp gauge, fuel gauge not work


Your 89 Isuzu trooper overdrive light won't come on and it won't shift into overdrive?

replace engine temp sensor. trans won't shift into o/d until engine has warmed up. there are two sensors, one for the temp guage and one for the computer.


How do you fix a temp gauge on a 1998 ford contour?

temp gauge is stuck on hot


Prelude temp gauge?

1996 prelude temperature gauge reads low temp


Why my Water temperature gauge doesn't work on 95 explorer?

only 3 reasons a temp gauge wont work the temp sender is bad the gauge is bad or the wire from temp sender to gauge is broken


Does the skeletal system regulate body temp?

no


How do you replace coolant temp sensor on a Isuzu Rodeo?

how do you replace coolant temp sensor on a rodeo


Temp gauge not working in Isuzu trooper after head replacement?

This is a long shot: Take a jumper wire from the engine block to a good chassis ground. Sometimes the engine/drivetrain is so well (electrically) insulated that various items won't work if the bonding strap was left off. You'll oftentimes find that the bonding strap is connected to the head and may have been overlooked during an r&r.


What sensor temp gauge 4.3?

The temp sending unit for the temp gauge is located on the drivers side of the engine between cylinders 3 and 5 spark plugs.


Why would temp gauge in car run cool?

Thermostat stuck open or no stat at all. Faulty temp sensor or Gauge.


Where is the transmission dipstick located on a 1996 Isuzu Rodeo?

the haynes manual says the fluid is serviced from the overfill port 1996+ (in corner of trany pan). -run car for 3 mins -while running in neutral -inside port, place temp gauge -wait until temp is 90-135 deg -pump fluid in with syringe or special pump until fluid starts to run out of same hole.. still doesn't make sense to me.. let me know if you find the special temp gauge.. good luck! -Danno oh yeah, no dipstick, system is sealed to get Isuzu dealers paid...