if v8 it is in water neck or right behind on intake mantifold /strait 6 water neck or intake on side moter
It runs from the oil pressure gauge to the sending unit on the engine.
The temperature sending unit on a 1977 302 engine is on the front. It is located in front of and to the right of the intake manifold.
How do you install a starter in a 1977 Chevrolet Caprice Classic with a 5.7 liter motor?
Lochaber Narrow Gauge Railway ended in 1977.
In a 1977 Monte Carlo, the temperature sensor is typically located on the engine block, near the thermostat housing. This sensor monitors the engine's coolant temperature and sends the information to the dashboard gauge. It can usually be identified by its electrical connector and is often found on the driver's side of the engine. If you need to replace or inspect it, ensure the engine is cool to avoid burns.
There are several sending units in that vehicle, need to know which one.
what is the process for installing new seat covers in a 1977 chevrolet corvette
How do I replace the power window switch on 1977 Corvette coupe
Ivor the Engine ended in 1977.
To wire up an alternator for a 1977 Dodge van with a 5.9-liter engine, first, disconnect the battery to ensure safety. Connect the alternator's positive terminal to the battery or starter solenoid with a heavy gauge wire, and attach the negative terminal to the engine block or chassis ground. Next, connect the field wire (often a small gauge wire) from the alternator to the voltage regulator, ensuring proper connections according to the wiring diagram specific to your vehicle. Finally, reconnect the battery and start the engine to check for proper charging voltage.
in the gas tank. Have to drop the spare tire and the tank to get to it.
The engine is a 1977 model