0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the length of a nv3500 transmission from the front of bellhousing to the rear seal in a 1991 Chevy 1500 2wd?
The length of the 1991 Chevy 1500 transmission is 37 inches. The bell housing will account for approximately 5.5 inches.
Do you have to remove transmission to replace the rear main oil seal in a 2000 Chevy cavalier?
You must remove the transmission are engine to replace the rear main seal.
How do you change the rear main seal on a 2001 Chevy Tahoe 4WD SUV?
The engine rear main seal can only be replaced with the engine or transmission out of the vehicle.
How do I replace the Rear main engine seal on a small block Chevy?
You will need to remove the transmission.
What is the rear main seal in a 1988 Chevy Camaro?
rear main seal is the gasket around the crank between the rear of the motor and the transmission. front and rear main seals are usual spots for oil leaks.
How do you change the rear main seal on a 2000 Chevy blazer?
you have to pull the transmission out-- or the enging which either is easier
How do you determine if the rear main seal is damaged leaking on an 2002 Chevy Tahoe?
You will have to pull the transmission out and remove the fly-wheel to inspect the rear main seal. It is a 1 piece round seal that slides over the rear of the crankshaft. If the rear main seal is leaking on that 2002, I would find that very odd.
How do you chenge a rear main seal in a 97 Toyota Camry 4 cylinder?
remove transmission, remove rear main seal, install new rear main seal, install transmission.
Why does oil leak from the seal of a manual transmission on a 1995 Chevy s-10 truck?
Assuming we are talking about the rear oil seal on that transmission, if it has been replaced and it still leaks, check the condition of the universal joints in the driveshaft.
How do you remove o ring seal from transmission that connect to drive line to 1983 Chevy van g20?
FIRST BLOCK THE REAR WHEELS SO IT DON'T ROLL WHEN YOU REMOVE THE DRIVESHAFT. Then take a screw driver and pop the rear seal out of the transmission tail shaft housing and then tap the new seal in with a hammer being carefull not to bend the seal.
Does trans. have to be lowered to Replace rear main seal 88 Chevy s10?
The engine or transmission has to come out, one or the other, which ever is easier.
How do you change a rear main seal on a 350?
how do you change a rear main seal in a Chevy 350 motor
