Ford Ranger XL

What is the location of the camshaft position sensor on 1997 Ford Ranger 3.0?

232425

Top Answer
User Avatar
Wiki User
Answered
2005-05-10 23:46:38
2005-05-10 23:46:38

near the firewall just left of center (or just towards the passengers side). it is located where the distributor would be on an older motor and is driven in the same manner. It also drives the oil pump.(not the sensor on top but the shaft below that is spun off the cam)

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


location of the camshaft sensor

Some of the 1992 Rangers had the camshaft position sensor on top of the engine in the same hole where the distributor used to be. Some Ranger engines did not use a camshaft sensor at all.

The 2002 Ford Ranger camshaft position sensor is located on the back of the camshaft. The rear engine plate will need to be removed in order to view the sensor.

were is the camshaft position sensor (cmp) location on a 1996 caprice classic

location of camshaft position sensor on 2001 exterra

show location of camshaft position sensor for 2002 Oldsmobile bravada.

The 2006 Dodge Durango camshaft position sensor is located on the back end of the head. The position sensor should be labeled as such.

The sensor is located behind the intake positioned just like a Chevy distributor. There is some wires coming off of it.

A camshaft position sensor reads the location of the camshaft and sends that information the engine computer. This is needed for fuel and ignition timing.

The camshaft position sensor, on a Ford 6.0 liter power stroke engine, is located inside of the rear engine cover. The sensor is on the back of the camshaft.

The camshaft position sensor is most likely located on the cylinder head of the engine. The location could vary depending on the manufacturer.

Location of camshaft position sensor on 2001 toyota avalon 3000 motor

The camshaft position sensor is on the front of the engine block. It is on the right front about half way up.

A camshaft position sensor detects which cylinder is firing and establishes the coil firing sequence. In a Kia Sedona, it is located at the end of the intake camshaft.

The camshaft position sensor is on top of the engine. It is on top of a shaft in the same place that older rangers had a distributor.

There is no "camshaft position sensor" in the 1999 ranger 2.5l motor so they have to have a crank position sensor. what kind of problems are you having? i might be able to help. you can email me at cmjbrodman@gmail.com. I have a 99 2.5 with a P340 code "camshaft positioning sensor circuit malfunction" Supposidly, it is behind the aux pulley.

There isn't one. It only has a dual vane crankshaft position sensor.

the camshaft position sensor is used to synchronize the fuel injection system with the opening of the intake valves. It synchs the cam shaft location with the crankshaft location It can be in a distributor or it can read a tone wheel on the cam shaft.

Where is the camshaft position sensor on a 2005 Expedition?

The 1995 for Crown Victoria camshaft position sensor can be found on the back of the cylinder head. The camshaft position sensor will be labeled as such.

where is the cam sensor located on a 2001 silverado ?


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.