answersLogoWhite

0


Best Answer

XX is not a standard marking. I do not know what you are looking at specifically however; the Gypsum Association has a web site that I use a lot http://www.gypsum.org/. The most common marking for fire ratting is either TYPE X or TYPE C. Look at the GA sit or find the manufacturer site and look for their markings. If the manufacturer does not have a site, it is possible that the product is not listed and should not be used in a rated assembly. Contact your local Building Official or GA for moré information.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the marking for fire rated drywall?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is fire code drywall?

It's drywall that has a fire resistant additive, and is also thicker.


How do you build a two hour fire rated drywall wall for commercial purposes?

You use 5/8 fire proof drywall on both sides.


Is fire rated drywall required for residential construction?

Fire retardant drywall should used when you finish off an attached garage as well as using a steel door on "passage" areas.


How do you build a fire rated wall?

A fire rated wall is rated as such because of the material used in construction. There is specific drywall board and rated doors to obtain a fire rating. The standards are 2 and 4 hour ratings unless referring to electrical equipment.


Is fire rated drywall type x heavier than regular drywall?

yes it seems to be...not sure how much but ive been a drywaller for 20-21 years.


How do you build a fire rated drywall ceiling?

You must use 5/*" sheetrock Local codes can vary - check with your building Dept


What is 3 hour drywall?

It is drywall that will be fire-resistant for 3 hours.


What is the burn time on gypsum drywall panel?

A 1/2 panel will last 30 minutes or so in a house fire. Fire rated Type X 5/8 will last about 90 minutes.


What is a 1 Hour fire-rated ceiling for a basement?

1 hour fire-rated ceiling for basement is basically, 2 5/8's drywall doubled up. Also anything protruding or flow-throughs need to be caulked with fire rated caulking. Make sure that when you hang the first sheet of drywall that you take, mud and then put the other piece up. That is what makes it 1 hour.


Is it possible to vent the hot air from a garage?

Hot air rises so placing a vent into the roof will allow the heat to escape naturally. Or you can buy a solar vent that drives a small fan to push the air out when the sun is shining. Make sure you have the vent properly installed to prevents leaks, birds, etc from entering the Roof or garage space You can add vents in your garage, but make sure that you are not breaking the fire rated drywall which is on any walls attached to livable space. This drywall is thicker and usually marked as 5/8" fire rated drywall. If you do cut into the drywall you should re-tape and mud around the opening for safety.


What is 3 hour?

It is drywall that will be fire-resistant for 3 hours.


Where can i find drywall access doors?

Pexsupply.com is a popular and well rated website where you can find drywall access doors. This website is set up well, and quite a few selections when it comes to drywall access doors.