Want this question answered?
Cell membrane, Nucleus, Cell wall, and axon terminal
The most command material used in photovoltaic solar cells is crystalline silicon.
-48V is used in the telecommunication equipment. The source of the -48V is a bank backup batteries that are always kept charged in the event of power loss. The typical range of voltage is -36V to -60V in this application. Why negative voltage is used is probably tradition as the modern power supplies that use this voltage are isolated and run the same as long as the positive terminal is 48V above the negative terminal.
The lysosome or peroxisome.
active transport
Current doesn't flow inside the cell. The cell is used to push current through an external circuit. The so-called "conventional" current flows out of the positive terminal of the cell, through the circuit, and back into the negative terminal of the cell. The confusing truth is that the actual physical carrier of current is the electron, which carries a negative charge. So the things that are actually moving and carrying the current through the circuit leave the dry cell from its negative terminal, physically flow through the circuit, and end up at the cell's positive terminal.
Current doesn't flow inside the cell. The cell is used to push current through an external circuit. The so-called "conventional" current flows out of the positive terminal of the cell, through the circuit, and back into the negative terminal of the cell. The confusing truth is that the actual physical carrier of current is the electron, which carries a negative charge. So the things that are actually moving and carrying the current through the circuit leave the dry cell from its negative terminal, physically flow through the circuit, and end up at the cell's positive terminal.
Normally they are used as if they were same but ground means that this connection is linked to earth, negative means that this connection is linked to a negative terminal. It is possible that someone has named the terminal incorrectly and named it ground instead of negative. Voltage between negative terminal and ground is normally 0, that means that they are on the same potential and that there is no danger of short-circuit.
Positive, because the negative terminal is usually used as the ground plane.
Cell membrane, Nucleus, Cell wall, and axon terminal
A rheostat is simply a variable resistor used to control current. It does not have a positive or a negative terminal.
No. It seems Zinc would always act as the negative terminal. Anode and Cathode are the terms used when we connect an external electrical source to the device. If positive terminal of an external battery is connected to the electrode then that electrode is named as ANODE. If negative terminal is connected then it is named as CATHODE. In case of chargable device, while discharging say P acts as negative terminal. Then while charging this negative terminal would be the anode. So if the device is a chargable one and Zn acts as negative terminal while delivering current to the external load, then the same zn would acts as anode while charging.
The com is your common terminal also the negative terminal where the black probe is pluged in. normally used on meter with 3 or more connectors and only the red probe change position
The input signal is assumed to have zero DC bias. Input stages will typically have a positive bias on the base or grid, respectively, of the first stage transistor or tube. So, the input terminal is more negative. ANSWER: The polarity of the capacitor is determined by the bias polarity as used. If the bias is negative then the capacitor negative terminal must be connected to it.
Anode is the negative terminal of a battery. It is made of Tungsten which is the same metal used in the filaments of bulbs.
Silicon
I think it is nothing