-48V is used in the telecommunication equipment. The source of the -48V is a bank backup batteries that are always kept charged in the event of power loss. The typical range of voltage is -36V to -60V in this application. Why negative voltage is used is probably tradition as the modern power supplies that use this voltage are isolated and run the same as long as the positive terminal is 48V above the negative terminal.
You will have to change the cart motor to one that operates on 48 volts DC and then add one more 12 volt battery (identical to the exsisting) in series with the batteries that are in the cart now.
The 36 volt motor will over heat (depending on the load of the motor)on 48 volts and melt the copper inside the motor you can rewind the copper inside to cope with the extra 12 volts.My answer would be not to try it as i have and it totaly melted the copper inside.
In the United States toasters run on 120 volts.
On your model number the figures after 400MH are the voltages for that ballast. A 40 represents 240 volts, 12 represents 120 volts and yours 48 represents 480 volts. Looks like this is a industrial fixture and not meant for residential use.
well it is measuring the amount of electricity energy used
In Europe the voltage is different, it is 220 volts, where as in the U.S. the voltage for electronics is 110 volts. That is why you need the converter so that you do not ruin your electronics.
You need to divide the 48 volts by the voltage produced by a single battery.
No.
Negative 48 volt DC voltage is simply a voltage that is negative 48 volts with respect to ground. This voltage is widely used in telecommunication systems.
48 VOLTS
+24 volts is not normally used for telecom equipment. -48 volts is the usual value. 48 was chosen as a compromise between safety and voltage/power efficiency. Minus was chosen over plus to manage corrosion effects of cabling in underground installations.
If a 48 Volt club car electric motor requires 48 volts, then it should be given a 48 volt power source, or something close to it. Too many more volts and it may burn out; not enough volts and it may not run or it will try to draw too much power and burn out the power supply.
A lot of commercial telecommunications equipment runs on 48 volts. There are also relays that use 48 volts. I'm sure there are many other uses for this. I'm not aware of any in a typical house, if that's what you're looking for. Perhaps certain water softeners, sprinkler systems, etc. run on 48, but the ones I've seen usually run on 12.
Put it in a bag of rice for 48 hours.
Lead-Acid cells are generally considered to deliver 2 volts, so you'd need 24 cells to get 48 volt. Easiest way of doing that would be to use two 24V batteries as used in truck and heavy vehicles.
Trigonometry is used effectively in electronics.
What is the KW of 4 50 amp rectifiers at a 48 volt DC system