Want this question answered?
All drains slope 1/4 inch per foot, minimum. Too much slope,though, can mean pulling water out of the trap or goose neck on a toilet.
slope intercept formula is given by y = mx+c where m is the slope and c is the x intercept so ur equation comes to... y=(0.25)x + 24
thanks you for your help
1" per 4' minimum.
an amber light signal.
90 degrees
All drains slope 1/4 inch per foot, minimum. Too much slope,though, can mean pulling water out of the trap or goose neck on a toilet.
The maximum number of drainage fixture unit on a 2" drain line depends on the slope of the drain line. 21 units are allowed if the slope is 1/4' per foot, and 26 units are allowed if the slope of the line is 1/2" per foot.
Maximum distance of the toilet to the drain is 6 metres (20 feet). The angle of drop is set by the branch at 112 1/2o, which equates to about 1/4" of drop per foot.
Usually toilet flange is glued down onto plastic drain pipe. There is a toilet flange that can be glued inside of plastic drain pipe also.
Yes as long as the drain has a trap and is vented
No. If you think about it, upstairs toilets actually drain through the walls and down under the foundation and footings, so you would have a 100% slope there. You can have too little slope, but never too much, since gravity is actually what drains a toilet. Yes you can. Pipes that run vertical are not a problem because friction is not acting on either the solid or the liquid matter. Where a pipe is sloping steeply the water can run away leaving solid matter behind.
On a standard toilet in America the drain is 12 inches from the back wall to the center of the drain.
The toilet itself is plugged or the pipe from the toilet to the drain is plugged. It may be that the tub and sink have their own drain pipe that may connect to the main away from the toilet drain. Plunge the toilet or sometimes if you fill a 5 gallon bucket with water and pour it into the toilet as fast as it will take it, that will flush out the line. It is a greater amount of water all at once an forces out what the clog is.
The drain from the toilet to the main drain is plugged and the branch to the shower is not. If the main floor toilet flushes, it is between the two toilets and not between the house and the sewer.
Your drain line is plugged somewhere after your shower and toilet line are connected. The reason for the gurgle in your toilet is because air is trapped in the drain and your toilet is the closest place for air to flow to. If you had a vent on your toilet trap arm then it would gurgle in the vent rather in your toilet but your drain is still plugged and needs to be snaked out and maybe your drain line needs to be examined for right grade or broken.
By plumbing codes, no.