0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is The Slope Of -5x plus 3y equals plus 3?
Convert the equation to the standard slope intercept form of y = mx + c, where the value of m is the slope. -5x + 3y = 3 3y = 5x + 3 y = 5/3x + 1 Then the slope is 5/3.
Y equals 3x plus 5 slope?
The slope equals 3
What is the slope of the line that contains the points 1 1 and 3 15?
Points: (1, 1) and (3, 15) Slope: 7
What is the slope of the equation 5x plus 4y equals negative 3?
5x+4y = -3 4y = -5x-3 y = -5/4 x - 3 Slope is -5/4.
How do you graph y equals 2x-3?
5
When 3 inch original sewer pipe is at the street can 4 inch be reduced to tap into it?
Yes. A reduction fitting can be used.
What size of pipe for 300 ft of sewer line?
I would use 3 inch for that.
How big is a sewer rod?
A sewer "rod" is normally no larger then 3/8 of an inch diameter BUT a SEWER Cable can be as large as 11\4" even the small sewer rods can have large heads to maintain sewers as large as 36"
What is 3 feet for every one inch?
If you're talking about a slope: 3 foot run over a 1 inch rise.
Is 3 inch or 4 inch better for sewer lines?
4inch or 100mm PVC sewer lines are the best way to go. as amater af fact if you are in Australia they are the legal way to go. 3" or 75mm is only used for stormwater pipes from the gutters.
Can you use a 3 inch pipe as sewer line?
In Tulsa Oklahoma you can, but i would still use 4 in.
What is the correct fall per for sewer 3 pipe?
1/8" to 1/4" inch per foot.
How do you install air gap in 3 inch sewer pipe?
By placing the waste 2x the diameter above the opening
Why is sewer water coming out of a pipe in your backyard?
A 3 or 4 inch pipe sticking straight up out of the ground? This is the clean out for the sewer line. If sewage is coming out of it, this means the sewer line is clogged or collapsed from there to the main city sewer. If you have a septic tank, the tank is full and needs to be pumped out.
What is the minimum slope for 6 inch underground sewer pipe?
1/4" per ft. is the lowest allowed. 1. Allowed by whom? Not many regulatory authorities specify the minimum slope of a 6" sewer pipe. 2. Why state in inches, typically engineers use a 2.0% or 0.02 / 100' form for the answer. 3. Using Manning's of 0.013 (although most PVC could use a 0.009 or 0.011 n factor, you can achieve the 2 ft/sec typical requirement with a slope of 0.005 or 0.5%, although it was stated to me that 0.0067 or 0.67% is the correct minimun slope to use. I am just trying to find that source which is tough as most authorities do not specify the minimum slope of a 6" pipe.
Will reminton 1100 20guage 3 inch shoot 2.75 inch shells?
yes it will. the rating shotguns are chambered for is the maximum size shell you can shoot. i have a 1100 LT chambered for 3 inch and i shoot 2 3/4 inch shells out of it mostly.
Which is steeper...a slope of -1 or a slope of -3?
A slope of -3 is steeper.
