This varies by state and local codes, although most use the NFPA codes. Google: NFPA minimum clearance woodburning stove
No. I wouldn't try it. Check on the number of amps that the stove uses. Then you can calculate what size wire you will need. The amp rating on a #12 wire is 20 amps. A 240 volt stove needs a minimum of 40 amps. This supply is brought to the stove on a #8 wire rated at 45 amps R90 insulation. This supply wire is protected by a two pole 40 circuit breaker situated in your electrical panel. If you use a #12 wire and apply the total stove load, the insulation will melt off the wire and short out.
A pellet stove is a form of wood burning stove except more efficient.
No, it will not harm the stove.
You can put a cabinet over a stove. Just be careful about what you put in the cabinet since it will get warm from the stove.
Can an apt. stove be plugged into a outlet
A fridge or a woodburning stove.
Yes, Bass guitars will burn just fine in your fireplace. Remember to remove strings, tuners, and pickups.
Andrew R. Addkison has written: 'Cooking on a woodburning stove' -- subject(s): Cookery, Wood Stoves
Have you had any luck on your request? I'm looking for the same information.
When the outside temp is higher than the inside temp, the warm air forces the cooler air in the chimney back into the stove/house. Hence the odor.
The Electric Stove was invented in 1896 by a certain Groff Copeman.
Benjamin Franklin invented many items we use today. One of the most famous items was the bifocal spectacle, or bifocal glasses. Other items include the Franklin Stove, which is a type of woodburning stove, and the lightning rod.
Usually 18 inches min. unless otherwise specified by the manufacturer.
18 inches
The prices for purchasing a cast iron wood burning stove range from approximately $200 for a simple model to over $4,000 for a modern design including a blower. Given the size and weight of this type of product, shipping would likely add several hundred dollars to the initial cost.
The gap around the stove to the wall really depends on the stove manufacturers guidelines. My stove has a gap of 50mm (5cm) all the way around. The UK building regulations 'document J' states that a minimum gap of 150mm should extend from the side of the front doors of the stove to the edge of the hearth and a minimum of 300mm to the front. A stove that is close to the wall will have poorer air circulation around it meaning the heat released to your room will be less. Think of it like standard UK radiator, it sits a few inches from the wall to allow air circulation, if it was flush to the wall all you are doing is spending your hard earned cash heating the wall. A lot of people seem to think that the gap around the stove needs to be 150mm to the wall but this is not the case.
Not the best wood. Rapid burn, rapid burn out, very high creosote production- if used other than as kindling, be sure to clean your chimney OFTEN.