when length of reinforcing bar is small and we have to provide longer reinforcement in that case the second bar is provided with proper overlapping with the first bar this overlapping is known as lap length.
the straight length of shall not be less than 12mm dia and 200mm length.
7.5d welding length 7.5d gap to 50d length
50* diameter of reinforcement
50d
You should not weld on concrete, as it can explode if heated
At first, the area of cross section of the weld, length of the weld, volume of the weld in cubic inches, weight of weld in cubic inches. To express in formula: Weight of Weld Metal = _ Êx ÊBase Êx ÊHeight Êx ÊLength Êx ÊWeight of Material.
In a fillet weld, the leg and size are the same for the convex weld.
Correct current,travel speed, electrode angle, arc length
A butt weld is a weld made between two straight cut profiles , a socket , or plug weld is made between a surface and a hole.
You should not weld on concrete, as it can explode if heated
Agni Steels' TMT bars undergo a comprehensive TMT treatment. In this process, the steel TMT bars receive a short, intensive cooling as they pass through the specially designed water cooling system after the last Rolling Mill Stand. Our steel bars are processed to bond better with concrete cement mixtures and maintain high strength while remaining convenient to bend and weld.
At first, the area of cross section of the weld, length of the weld, volume of the weld in cubic inches, weight of weld in cubic inches. To express in formula: Weight of Weld Metal = _ Êx ÊBase Êx ÊHeight Êx ÊLength Êx ÊWeight of Material.
by using blueprints to a perfection. the right number of mats, size of rebar, the right spacing for bond beams, the right number of ties or cad-weld as per code as well as inspection. making all your tie-ins to code and due not miss any revisions or details.
Toughness
Absorbs water and nutrients:))
Too long an arc length allows the arc to wander creating a poorly shaped weld. The slag is usually too thin and can allow Oxygen in the air to attack the molten puddle which causes Porosity in the weld. Too short an arc length buries the slag and creates less heat which traps the slag and impurities. Keep in mind that electrode coatings help determine the correct arc length.
The required size for a seal weld per AISC is eighteen foot length. AISC also specifies minimum weld size based on the thicknesses of the members joined.
minus weld gaps and takeoffs from total then multiply for angle.
Solder glaze or JB Weld will not work on aluminum baking sheet. These bonding materials are used only for the surfaces of metal, wood, fiberglass, PVC, ABS, concrete, glass and fabric. This material should avoid clean slick or oily surfaces.
I use 1/4 x 1/2 mild steel bars. Easy to weld or drill and your average burglar can not get through them without a sackful of metal cutting tools.
Slag is normally seen as elongated lines either continuous or discontinuous along the length of the weld.