I`m Not Sure How To Put This. Let Us Look At Safety First. You Can Remove Them Yourself If You Have A Very Good Set Of Jack Stands To Put The Front Of The Car On. Remove Them Then Take Them To A Shop Or Parts House That Can Press The Springs Down To Remove And Install The Struts. Then You Put Them Back On. I Would See If I Could Furnish The Struts And Have A Good Shop Install These For Me. You Probably Will Find It The Best Way To Do This. But As Stated You Can Do Some Of It Your Self. Good Luck
how to replace rear shocks on a 1994 acura legend coupe
The new hood will fit as long as its between 91-95 and if you have a coupe the hood needs to be from another coupe, the sedan hood will not fit on the coupe or vice/versa. Hope this helps!
3.2 l v6
The way to replace the thermostat on a 91 Acura Legend Coupe is to drain the radiator and remove the throttle and cable box. Remove the top of the radiator hose and the bolts. The thermostat will be inside.
10mm
Yes it will as long as is the same generation models. the 1991 model up to 1995 sedan and coupe as the same engine mount even the type 2 will fit , and some of the 1996 ,97 rl
On my '94, I went through dipstick. Make sure you get the HONDA/ACURA fluid from the dealer.
i had a 1990 acura legend my blower motor was located under the passenger side dash board
The 1989 Acura Legend fuel injection relay switch can be found in the fuse box. The fuel injection relay switch will be in the third column, third from the top.
They really never did. The Legend moniker was dropped in for the North American market for the 1996 model year, however, they kept the "L" as part of the two letter model designation. IE Acura CL is just a Coupe Legend, and the TL was the Sedan Legend.
smooga! si esta nocha el rahol, jazca manara!
To reset the ABS light on a 1994 Acura Legend Coupe you will first need to find the fuse or relay box under the vehicle's hood. Remove the 3 15 amp fuses located in this box. Replace the fuses after approximately 30 to 60 seconds. This will reset the ABS light.