Backbones
Vehicles with an automatic transmission may have lines that carry transmission fluid from the transmission to a separate tank on the bottom of the radiator.
if you are asking about the cooling lines for the transmission that connect to the radiator, its easy. first disconnect the lines from the radiator (2 lines, usually on the bottom opposite the radiator outlet) then disconnect the lines from the transmission. remove the brackets holding them on, then remove.
Electrical transmission towers are meant to hold the power lines and to carry electricity.
The virtual diameter of the conductor becomes greater to carry more current
High power transmission lines carry several hundred amperes up to 2000 amps at voltages up to 500 kV or higher
You can disconnect the 1996 Jeep transmission lines with a 9/16 open end wrench. Be prepared for transmission fluid to come out of the transmission lines.
The major material used in the construction of transmission lines is aluminum alloy. Steel is also used to reinforce the lines. No insulation is used for overhead transmission lines.
the basic parameters of transmission lines are R,L,C and G...........
There are no vacuum lines running to the automatic transmission.
The transmission lines on a 2000 GMC Jimmy 4x4 are replaced by disconnecting the lines at the radiator and then the side of the transmission. They are then removed from the bottom of the vehicle and new lines put in place.
The broken white lines down the middle of the road serves as the separate lines of traffic or to protect any traffic that may be turning right.
AC transmission lines are 3-phase, DC transmission lines don't have phases. It doesn't matter where they are from.