Want this question answered?
No, even though these are parallel circuits, the voltage drop across each device is not the same in house hold circuits, or anywhere, for that matter. Different devices pull different currents. A toaster, for instance, pulls many times what a light bulb pulls. Since wires do not have truly zero resistance, those differing currents result in different voltage drops across the wires that lead to the devices. That small voltage drop in the wires results in a different voltage drop across each device, even though the device/wire is connected to the same voltage source.
No. You can have multiple devices on a series circuit. How about a low voltage Christmas tree light set. There you may have 15 or 20 lamps in series.
Whenever you are working over a device and getting a constant voltage supply ,, and all of a sudden .. the light gets off and the device is off. it means a device was working over some specified voltage and it comes to 0 instantly . the voltage changes . this is called voltage fluctuation .
it all depends on the voltage the light bulb can sustain.
noyou can not
It is basically a photodiode with no reverse biased voltage is applied to it . it generates the potensial across it when exposed to light
radiometer
Obviously asits name implies it senses oil pressure. If it is for a gauge it usually is a device that changes resistance or generates a voltage as the pressure on it changes. If it is for a warning light it is usually a spring loaded switch.
The term means: capable of producing a voltage when exposed to radiant energy, especially light. Photo-=light (photons are what light is made of) + -volt- =voltage (or electric current) + -ic = pertaining to. Pertaining to something that can produce voltage from sunlight.
fiber conventer
When the ignition is turned on, battery voltage passes down the wire to the alternator to 'excite' the alternator when the engine starts. When the engine starts and the alternator generates a voltage, the light is extinguised by the charging voltage cancelling out the battery voltage coming down the wire. If and when the alternator completetly fails the the light will come back on as there is no sancelling voltage. if the alternator produces a voltage lower than the voltage from the ignition switch then the battery light will glow.
A device that is sealed and will not allow its potential internal hazard be exposed to its external environment.
Some lighted yo-yos have small batteries that light them as they spin. More rarely, there is a friction device that generates energy from its spinning to power a small LED.
Also known as a thermocouple- device generates very small eletrical current from heat of the pilot light, which permits gas valve to open only when pilot light is lit.
An LED (Light Emitting Diode) will fit into this category, or a torch (flash light) bulb.
No, even though these are parallel circuits, the voltage drop across each device is not the same in house hold circuits, or anywhere, for that matter. Different devices pull different currents. A toaster, for instance, pulls many times what a light bulb pulls. Since wires do not have truly zero resistance, those differing currents result in different voltage drops across the wires that lead to the devices. That small voltage drop in the wires results in a different voltage drop across each device, even though the device/wire is connected to the same voltage source.
It shines (it generates light).