MINFITTER
It is called "engine splash shield"
remove plastic rivets and bolts holding bumper within fender well, between lights near hood latch, and bottom of bumber, be careful taking bumper off to prevent cracking. exact opposite for installing bumper
its the resivoir tank toward the left of the engine and then there is one directly on the radiator but you have to take off the 3 plates above the bumper under the hood 1 is plastic 2 are medal
Super glue
There are many. Start buy draining by removing the plastic shield under the car behind the bumper. you then have to remove the bumper cover and loosen the front of the bumper assembly. From there the radiator and fan are connected to each other. Disconnect all hoses clamps and brackets then it will come out. For more details I suggest North American Motoring for all MINI info.
Crawl under the center of your vehicle, and there will be a rubberish cover under your radiator, it has 5 or 6 plastic screws holding it to the bumper, pull those out being careful not to break them, and you will see a plastic Phillips screw in the center of your radiator, turn it to the left and the screw will eventually fall out, should drain around 7 1/2 liters.
First remove the front clip (headlights and grille and plastic covering the bumper.) The rest will be obvious.
Remove the front bumper to remove the radiator
typically it's located on the left side of the engine bay (if you're standing at the front bumper) it's attached to a plastic tank. It looks nothing like the radiator caps from back in the day that were made of metal and sitting right on top of the radiator itself.
Behind the front bumper. Under the front, just below the radiator is a plastic skid plate. Just above this skid plate. There is 1 on both sides. They have an orange plastic plug clip.
that depends. does your 325e have a aluminum bumper or a plastic bumper? if it has the aluminum bumper, you should order new bumper shocks for an post face-lift 87 model. post 8/87. the reason? the shocks that fit aluminum bumpers are very long, and if u attach a plastic bumper, it will stick out too far. if the 325e has a plastic bumper, then everything will be as easy as detaching and re-attaching your bumper.
Passenger side attached right to the radiator. kind of in a bad spot toward the bumper underneath the bumper and facia
probably plastic