answersLogoWhite

0


Best Answer

195 to 210 degrees is normal.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the normal water temperature for a 91 s10 with a 4.3 motor?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the normal temperature for a 94 s10 blazer with a 4.3 motor?

195 degrees F


What is the normal water temperature for a 1999 Chevy S10 2.2L?

Assuming you have a 195 degree thermostat, it should be aprox 195 degrees plus or minus a few.


What is normal oil pressure on a 2002 Chevy S10 V6?

The normal oil pressure on a 2002 Chevy S10 V6 is around 40 PSI. This will vary slightly depending on the temperature of the engine. Hot at idle in drive, 20 psi is also normal.


Will a 1986 s10 motor fit in a 1985 s10?

Yes.


Replace water temp sensor on Chevy S10?

Remove the tail gate then replace water temperature sensor.


Where is the temperature door control motor in a Chevy S10?

Behind dash assembly. Dash assembly must be removed to gain access.


Why doesn't your temperature rise to normal while operating your 1995 s10 blazer 4.3l 4x4?

Stuck open thermostat.


2000 S10 Chevy engine rebuild cost My Chevy s10 has a broken water pump which caused the engine to over heat and burn up the rings Motor need rebuild and water pump Whats the cost?

999.99


How many motor mounts are on a S10 Blazer?

2 motor mounts.


Will a motor from a 1990 s10 blazer fit in a 1995 s10 blazer?

Yes it will fit.


How do you put on a single wire water temperature sending unit on a 1994 s10 Chevy?

There are actually two water temperature sending unit on a 1994 S10 Chevy. Please locate the unit close to the thermostat housing, and not the one between spark plugs. The single wire water temperature sending unit should then be attached to the temperature gauge. The two wire unit, the one between spark plugs, would be connected to the engine control module.


How do you change a starter on a 1998 s10 The motor mount gets in the way?

To change the starter on a 1998 s10, the motor mount will have to be removed. Support the motor on a jack with a board on the top of it, and remove the mount to get to the starter.