0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What am I doing wrong when I can't get the solder to stick when soldering a copper pipe?
Not cleaning the pipe or joint enough, not using flux, or not heating the pipe or joint enough. You use the blue tip of the flame on the joint and the capillary action sucks the solder into the joint. You have to clean the pipe with sandpaper or steel wool, the joints with a fitting brush on the inside, and use a proper flux and solder.
Ring to seal a pipe joint?
Gasket
What is a dogleg offset pipe?
Type your answer here... Generally its a non-enginered angle in a piping weld joint occurring in the axial run of pipe.
Difference between seamless and erw pipe?
ERW (Electric Resistance Welding) pipe is manufactured by rolling metal and then welding it longitudinally across its length. Seamless pipe is manufactured by extruding the metal to the desired length; hence ERW pipe has a welded joint in its cross-section, while seamless pipe does not have any joint in its cross-section through-out its length.
How can you re-solder a joint in a copper pipe without removing it The water has been shut off and the joint is running vertically but when heat is applied more water sweats out?
You cannot sweat copper pipe if it has water in it. You must remove the water first. Even the steam from water will keep you from successfully sweating a joint without leaks. bob...
What is key lock joint in rtr pipe?
RTR pipe is Reinforced Thermosetting Resin Pipe (RTRP) or fiberglass pipe. A Keylock joint is a restrained joint, nylon rods (keys) slip into groove on the spigot and in the bell of pipe and restrain the pipe from pulling apart. The rods (keys) are removable.
What is marijuana put into?
a joint, blunt, tobacco pipe(also called a bowl or piece), a bong, a vaporizer, a bubbler
What am I doing wrong when I can't get the solder to stick when soldering a copper pipe?
Not cleaning the pipe or joint enough, not using flux, or not heating the pipe or joint enough. You use the blue tip of the flame on the joint and the capillary action sucks the solder into the joint. You have to clean the pipe with sandpaper or steel wool, the joints with a fitting brush on the inside, and use a proper flux and solder.
Ring to seal a pipe joint?
Gasket
Piping system?
Pipe Expansion Joint
How do you seal cpvc pipe into brass fitting?
Pipe joint compound or Teflon tape
What is the purpose of pipe coupling?
To joint two or more sections of pipe into a single continuous conduit.
What sealant to use on gas pipe connections?
Approved pipe joint compounds
How do you loosen a pipe joint that has Teflon tape on it?
With a wrench
What is pipe grooving?
Pipe grooved at end of pipe with grooving machine. Butt grooved pipe or fitting together and slip rubber seal onto end of each grooved joint, apply light coating of grease made for grooved piping on rubber seal. Coat split coupling for joint with grease also and put coupling around joint and clamp together tightly.
How do you clear a blocked waste-pipe?
call the plumbing joint inc...
What is the filet weld size required for weldolets to main pipe joint?
wildly welding main pipe the are fillet weld or butweld
