0
What is the procedure for replacing engine mounts on a 1998 Audi A4 B5 2.6L v6?
Wiki User
∙ 12y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why your 1998 Honda civic ex shakes when idle?
A 1998 Honda Civic shakes when it idles usually due to worn engine mounts. Open the hood and check the engine mounts. See if they are either cracked or brittle. Since the mounts can not absorb the vibrations it will be felt in the cabin.
How do you change the motor mounts on a 1998 buick century?
General instructions for replacing motor mounts on ANY vehicle: Put a floor jack under the engine, distributing the weight evenly using a board or some other object, just take the weight from the motor mounts by jacking up the engine slightly. Loosten the nuts that hold the engine to the motor mounts, jack up the engine until you have an inch or two clearance. finish removing the motor mounts, then put the replacment motor mounts in the same place. Lower the engine back onto the motor mounts, but keep the weight off the motor mounts until you have put the nuts back in place. After everything is back in place, take the rest of the weight off the jack and you're done.
How do you steps on replacing intake manifold gasket on a 1998 Chevy venture?
extremely difficult without removing the engine. i have seen some drop the engine down about a foot by disconnecting the motor and transmission mounts & did not disconnect alot of lines and were able to change the intake gasket.
How much should it cost to replace motor mounts on Hyundai Accent 1998?
About $12 a piece (accents have four engine mounts) plus labor.
How do i install motor mount on a 1998 ford explorer 4.0?
explorer engine mounts removal
What kind of difficulty will you face when replacing a 1998 Ford 4.2L V6 with a 1998 Ford V8?
you'll have to modify motor mounts and change wiring harness "pretty tough".
Where is the crankshaft position sensor on a 1998 Chrysler Sebring 2.5 engine?
It mounts to the top rear of the transmission bell housing.
Will a 2000 Chevy 3800 Series II engine bolt in to a 1998 Camaro that had a 3800 Series II engine?
Yes, you just have to change a few things like your mounts and pulleys if the engine came out a fwd just exchange with your original mounts and pulleys and it should work.
Will a 1998 ford escort engine fit a 1999?
It should, but just to be sure always check to see if the engine mounts line up; as well as the electrical connections>
Where is the engine block drain plug for a 1998 s10 V6 Blazer?
There would be block drains located on each side of the block very close to the engine mounts.
Where is the crankshaft sensor on a 96 Dodge Durango?
Dodge did not produce the Durango until 1998. It is located on the bell housing on the right side of the engine where the transmission mounts to the engine
Can you replace a 1998 buick regalskylark 3.8 or 3.3 liter engine with a buick 3.1 liter engine?
You can replace your 1998 Buick 3.8 liter engine with a Buick 3.1 liter engine. You will need to change the motor mounts and some of the wiring harness will need to be modified.
