answersLogoWhite

0

  • Fuel and Engines
  • Head Gaskets and Valve Covers
  • Saturn S-Series

What is the procedure for the removal of cylinder head on 1997 Saturn SL2?

User Avatar

Wiki User

βˆ™ 2004-06-30 10:38:54

Best Answer
Copy

Hey Kenneth==It is a pretty involved procedure. Get a manual on your car from either a local parts store or MOTORLIT.COM. Good luck Joe

2004-06-30 10:38:54
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

Where is Fuel filter for 1997 Saturn s2?

Under the brake master cylinder.


What kind of motor is for a 1997 Saturn SC1?

A 1997 SC1 uses a single overhead cam, 4 cylinder engine.


What Causes your 1997 Saturn SL1 to misfire in Cylinder 2?

Bad plug, plug wire, burnt valve, blown head gasket, on that cylinder.


1997 Isuzu Rodeo V-6 Starter Solenoid Removal what is the Procedure?

How to remove the starter from a 1997 Isuzu Rodeo 4X4 automatic


Were all the 1997 Saturn wagons 6 cycle or 4 cycle?

Not cycle.......cylinder, all were four cylinder. ^^^^ Yupp yupp! The L-series moved on to 6 cylinder engines


Where is the clutch reservoir on 1997 Saturn SL1?

Below the brake master cylinder and to the left (drivers side) of the vehicle.


How do you replace the speedometer cable on a 1997 kawasaki voyager?

remove cluster and replace cable. Reverse removal procedure for installation.


Transmission relearn procedure for 1997 Saturn car?

Go to www.valvebodybuilders.com/tech_saturn_relearn.html that worked when I replaced my vavle body.it explains why and how to relearn TATT tranny.


Where to add clutch oil in your 1997 Saturn SL?

It's going to look like your power brake reservoir. It is the reservoir for your clutch slave cylinder.


Where is the thermostat located on a 1997 Saturn SL?

Follow the top radiator hose to the engine, what that mounts to is the thermostat housing, remove this and there is your thermostat. * ** *** **** ***** Actually, on my 1997 SL2, the thermostat is on the bottom radiator hose. I would check the "Saturn Thermostat Pictures" link below, which also has installation and removal instructions.


When was Saturn Rukh created?

Saturn Rukh was created in 1997.


I have gas in my oil and low compression in 4 cylinder?

I have a 1997 Saturn SL 1.9 with gas in the oil and 30 psi in #4 cylinder the other 3 cylinders are at 180


How do you install an ignition lock kit in a 1997 Saturn SL2?

If it is like the '97 SC2, which it likely is: Remove the plastic cover from around the steering column. Turn the old ignition cylinder to ACC (I know what you are about to say... If you can turn the cylinder, why replace it. Unfortunately I can't answer that. I had to drill out the old lock to replace the one on my saturn. Please consult a locksmith before doing so. You don't want to drill into the wrong parts.) With the old cylinder turned to ACC, there is a small button on the side (probably upper right towards the air vents) Push this button in and the old cylinder should pull out. Installation is reverse of removal (without the drilling...)


When was Removal - band - created?

Removal - band - was created in 1997.


Where is number four cylinder 1997 Ford Escort?

were is number four cylinder 1997 ford escort


Would a 1997 Honda Accord sunroof 4 cylinder fit 6 cylinder?

would a 1997 honda accord sunroof 4 cylinder fit a 6 cylinder?


What does a heater core in a 1997 dodge Saturn heater core look like?

There is no such thing as a 1997 dodge saturn! Try again.


Where is the transmission dipstick for a Saturn sl2?

1997 Saturn sc2 loction of transmission dipstick


Is there a fuel safety switch for 1997 Saturn SC2?

No, there is no inertia switch on any Saturn.


Is water pump connected to timing belt on 1997 Saturn sl2 1.9 dohc?

No, there is no timing belt on any of the the 4 cylinder Saturns, they all use an internal timing chain.


What cylinder is the number 1 cylinder on a 1997 Jeep Wrangler 4.0?

cylinder #1 is the first cylinder on the front of the engine


What are the 1997 Saturn SL1 warning lights?

show warning lights and what they mean on 97 Saturn


What is the labor and materials cost to replace a slave cylinder in a 1997 Saturn SL2?

Its best to buy the slave and master cylinder prebled from the dealer. Its $140 or so but it saves alot of hassle if you dont bleed it right. Labor...Each side twists in to there perspective locations and then 2 bolts hold on the slave cylinder to the tranny.


Where is the IAT sensor on a 1997 Jeep Wrangler 4-cylinder?

on the intake


How do you reset an oil light in your 1997 Saturn SC2?

99 percent sure there is NO oil reset procedure for the '97 sc models. If your oil light is on it is bc you are LOW on oil. Add oil immediately