this applies to 2.4 and v6 models. the 2.2 does not have a cam shaft sensor.---four cylinder models-disconnect the electrical connector from the camshaft sensor. remove the mounting bolt from sensor. replace the "O" ring and lightly oil it with clean oil. ( sensor is in camshaft cover ) then install.--v6 models,-remove drive belt, take off Power Steering pump, do not take off hoses. just set it aside. now you can see sensor, remove hold down bolt and electrical connector, then pull sensor straight up. installation is reverse of removal. have a good one !!
The 1997 Chevy Malibu crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.
2010 chevy malibu intake position sensor
is it difficult to change the fuel sensor on a 2007 Chevy Malibu
fuel shut off sensor located on Chevy Malibu
Where is located pressure sensor on Chevy Malibu 1999
Very simple. Unplug the wire to the sensor, unscrew/remove the sensor, install new sensor and plug it in. You're done. Have fun.
HOW TO REPLACE A STARTER ON A 1998 CHEVY MALIBU
how do I remove a watwr pump on a 2005 chevy malibu
if you do it yourself,you only pay for sensor!! to change sensor on a v6, remove power steering pump and set aside do not remove hoses,sensor is under pump!! remove hold down bolt then wiggle it out!!
The 2004 Chevy Malibu crankshaft position sensor location is dependent upon the type of engine. In most cases the crankshaft position sensor is on the back of the engine.
Remove drive belt, remove power steering pump, camshaft sensor located behind p/s pump. Disconnect wiring, remove retaining bolt, remove camshaft sensor.
Where is coolant fan switch located on 1998 chevy Malibu with 3 .1