Timing belt crank sprocket
Should be behind pulley directly above crankshaft
no those cars suck
i had the same problem with my 02 intrepid it was the idler pulley to the ac belt $19 to fix it.
The camshaft position sensor is located behind the water pump pulley. If looking directly at the pulley, it is at about the 10 O'clock position. TechJK ---------------------
That is the water pump pulley.
Check with your local auto repair shot to see if they rent tools. If so, they likely carry a crankshaft pulley remover. I'm in the process of changing the water pump on my 2002 Intrepid and I rented the tool. Now I have to find the installer because the one they had didn't fit my pulley.
This depends on which engine your wrangler has in it as to exact location and type. On the 2.5L 4-cyl, 4.0L & 4.2L 6-cyl it is on the front center of the engine behind and attached to the pulley directly above the bottom pulley (Cranshaft pulley). On the 2.4L 4-cyl it is above the bottom center pulley (Crankshaft pulley) and a little to the driver side front of the engine. As a general rule, find your "bottom" radiator hose and follow it to the engine. In most cases it attaches directly to the water pump.
The power steering pump on a Ford 5.4L engine is at the front of the engine, directly below the water pump and beside the crankshaft housing. Below I have posted a picture so you can see where each of those are. This is the pulley diagram. The pump is directly behind the pulley. Hope that helps.
Buick big blocks have the oil filter located directly below the distributor, just outside and behind the lower pulley.
loosen bolt at center of tensioner pulley slightly, locate Phillips screw directly behind pulley facing up and turn counter clockwise to release tension on belt.
The crankshaft pulley is the lowest pulley on the engine. Looking at the engine from the front which is looking at it from the passenger side fender the crank pulley is on the bottom of the engine and has a pulley with a pulley behind it with teeth on it.
You will need a special 3 jaw puller and an insert for the puller to push against.