As the android, Data, from Star Trek would say, it's to assure the drum is operating within normal parameters. If the drum begins to spin too fast the centrifugal switch (actually two switches in unison) cuts off electrical power to the motor to prevent it running away.
The purpose of a spring washer is to offer spring force, sustain a load, or provide a method to absorb shock. This is achieved through the design of the washer of which its namesake describes. Much like the shocks of a car the spring washer performs the same duty at a much smaller level.
the purpose of it is to connect the valve springs to the spring keeper to make a vale-springkeper it helps maintain the engine so it doesn't blow up and so the engine doesn't ignite
It most likely shakes when it spins because when it washes, the load gets greater or heavier on one side. As a result, when it spins centrifugal force causes the heavier load to overcome the weight of the washer, causing it to spin.
It actually depends on the washer.
The supply hoses are hooked up wrong. Hot is on the cold and since it rinses in cold, that means the last water in the tub is hot. Set the tempratue control to cold and start the washer. I bet the water is hot. Move it to hot and it will be cold. Just switch the hoses.
Centrifugal force in a washing machine occurs during the spin cycle. The spinning motion of the washer makes the clothes cling to the side of the washer drum, while the water is being sucked out by centrifugal force.
The relay switch for the washer motor on a 2001 model Peugeot 406 Estate is located at the controls of the windshield washer. It is near the washer fuse.?æ
The 2007 Toyota Avalon windshield washer relay switch can be found in the fuse box. The windshield washer relay switch will be in the third column, second from the top.
* Single washer * Double purpose * Washer with dryer
The car is an automatic.This machine is fully automatic.The automatic washer has broken down.
check the lid switch it is under the top of the washer and is usually activated by a pin attached to the lid of the washer
whats the washer used on a neutral safety switch
it's the turn signal,wiper,washer,cruise,and emergency switch all in one.
Sorry.. i meant washer switch on steering colum
The purpose of a spring washer is to offer spring force, sustain a load, or provide a method to absorb shock. This is achieved through the design of the washer of which its namesake describes. Much like the shocks of a car the spring washer performs the same duty at a much smaller level.
The owners manual list fuse number 22 as: Wiper Switch/Front & Rear Washer
If you are sure the lid safety switch is at fault do not bother with it, they are cheaper and easier to replace