Major types of Absorption columns are liquid-liquid absorption columns, Gas-liquid absorption columns.
EXACTLY NO WHY BECAUS LPT IS LIQUID PETROLIUM GAS,THAT MEANS WHER THE GAS GET THE LIQUID STAGE AT THAT POINT THEY CATCH THE LIQUID AND THEY COMPRESS THE GAS AND STORE IN A CYLINDER EXACTLY NO WHY BECAUS LPT IS LIQUID PETROLIUM GAS,THAT MEANS WHER THE GAS GET THE LIQUID STAGE AT THAT POINT THEY CATCH THE LIQUID AND THEY COMPRESS THE GAS AND STORE IN A CYLINDER
There are many uses with ammonia. We use liquid in refregirators.
No.Screw compressors can handle a little bit of liquid,because of internal slide valve.Reciprocating compressors can not handle liquid.
In a packed or tray column where you have vapor flowing up and liquid flowing down, there is an upper limit to how fast the liquid can drain downwards. The point at which liquid cannot flow down as fast as it is coming into the column is the "flooding point". The actual flooding point is partly dependent on how fast the liquid can flow down with no vapor flowing upwards and the rate at which vapor is trying to flow upwards. Cross sections of the column occupied by vapor are not available for liquid flow - effectively reducing the cross-section for downward flow of the liquid. You also get entrainment of liquid in the upward flowing vapor and drag on the liquid as it fights the direction of the vapor flow - the vapor wants to go up while the liquid wants to go down. This additional drag also slows down the flow of liquid trying to drain downward in the column. There is an analogous condition for two-phase liquid/liquid extraction columns.
low pressure liquid
Liquid
It is fitted on discharge line after condenser, where the gas enters in liquid forms.
Liquid receivers are used to store the liquid refrigerant after it leaves the condenser. It should be located below the condenser to enable natural flow. The receiver may be constructed either vertically or horizontally and should have sufficient capacity to hold the entire system's refrigerant charge. The design should be such that only liquid refrigerant leaves the receiver and enters the liquid line. by vishal mahnn
A queen valve is the service valve (isolation valve) located at the inlet of the liquid receiver (between the condenser outlet and the liquid receiver). The king valve is the service valve at the outlet of the liquid receiver (between the liquid receiver and the liquid line). Queen valves seem to be in use much less than king valves.
A communications receiver is a radio receiver used for communications. It receives a transmitted signal and sends it further along the line till it is converted into sound.
The discriminator, and the ratio detector, perform the same function in an f.m. receiver as the detector does in an a.m. receiver, i.e. it recovers the modulation.
Communicattion is a process.It has a purpose,a receiver and a speaker.
The receiver was in that pain at one point too. You have to think about how Jonas will become the receiver at one point and his whole purpose in live is to be this person that everyone respects but does nothing.
Liquid refrigerant charging of a system is normally accomplished in the liquid line. For example, when a system is out of refrigerant, liquid refrigerant can be charged into the king valve on the liquid line or receiver.
Ensures that only liquid refrigerant continues on to the Thermal Expansion Valve.
When the Smart Card and receiver are successfully "married," the receiver will only display the authorized programming. Therefore the overall purpose of the smartcard is to authorize the receiver to receive the programming that you as a customer are subscribed to.